AT35A Bogen Communications, Inc., AT35A Datasheet - Page 2

• Manufacturer Part Number: AT35A
• Description: Attenuator; 10-Step Plus Off Speaker; 35 W; Single; 4 1/16 in.; 3 3/4 in.
• Manufacturer: Bogen Communications, Inc.

Specifications of AT35A

• Attenuator Type: 10-Step Plus “Off” Speaker
• Capacity: 35 W
• Height: 3 3⁄4 in.
• Number Of Gangs: Single
• Width: 4 1⁄16 in.

Attenuator Installation
1) Cut a rectangular hole 4-
2) Pull approximately 12" of the amplifier and speaker cables
3) Push each of the separate cables through the electrical box entry
4) Rotate the two screw-mounted tabs down against the box and
5) Begin to tighten both of the electrical box screws until the box is
6) Make all the necessary electrical connections as shown in the
7) Remove the protective plastic film covering from the attenuator
8) Mount the attenuator to the electrical box using the 4 screws
or supplying of products, even if Bogen has been advised of the possibility
of such damages or losses. Some States do not allow the exclusion or lim-
itation of incidental or consequential damages, so the above limitation or
exclusion may not apply to you. This warranty gives you specific legal rights,
and you may also have other rights which vary from State to State.
Products that are out of warranty will also be repaired by the Bogen Factory
Service Department -- same address as above or call 201-934-8500. The
parts and labor involved in these repairs are warranted for 90 days when
repaired by the Bogen Factory Service Department. All shipping charges in
addition to parts and labor charges will be at the owner's expense. All
returns require a Return Authorization number.
where the attenuator is to be mounted.
through the hole.
holes and pull about 6" of cable out of the front of the box.
slide the electrical box into the opening until it stops against the
wall.
held firmly in the wall. Rotate the clips on the screws into place
and clamp the box against the wall.
“Attenuator Wiring” section on the front of this sheet.
face plate.
provided. Using a Phillips head screwdriver, screw the attenuator
into place.
1
/
16
" wide and 3-
3
/
4
" high in the sheetrock
08/10/2004
50 Spring Street, Ramsey, NJ 07446, U.S.A.
Tel. [phone], Fax: [phone], www.bogen.com
Entry holes
Screw-mounted tab
Rotated screw-
mounted tab
(down)