WL-BFL225S-DW12 Wamco Inc., WL-BFL225S-DW12 Datasheet - Page 5

• Manufacturer Part Number: WL-BFL225S-DW12
• Description: LED MOD 2LED 12V WHITE .72W
• Manufacturer: Wamco Inc.
• Type: LED Moduler

Specifications of WL-BFL225S-DW12

• Angle, Viewing: 120 °
• Color, Emitted: White
• Luminous Intensity: 26 lm
• Power: 0.72 W
• Voltage, Rating: 12 V
• Lead Free Status / Rohs Status: RoHS Compliant part

F-LED 225S
F-LED 225S
INSTALLATION
INSTALLATION
▣ Determine number of modules, pitch and power supplies needed based on channel depth, stroke,
cover materials, total power consumption of the modules, etc.
Tel: [phone] Fax: [phone] Email: [e-mail] Website: www.wamcoinc.com
Wamco, Inc. 11555 Coley River Circle, Fountain Valley, CA 92708
1) Clean inside the channel letters.
2) Remove VHB tape on the backside of the modules and attach modules
according to the layout determined. For secure mounting, use screws or silicone.
3) Connect modules in series or parallel with wire nuts or electric tape after
considering the maximum number of the module in series. Cap all unused
wires. Place silicone into the wire nuts for secure outdoor protection.
Check polarity. All connections must be Red (+ : Positive) to Red and
White (- : Negative) to White.
4) Drill holes at the bottom or side of the letters for the wire connection to
DC power supplies, put the bushings into the holes and thread wires out of the
letters.
5) Connect DC wires from the letters to DC power supplies and AC wires from
input power source to DC power supplies. Check DC polarity (+ : Positive,
- : Negative) and AC connection (L, N, FG : 1 phase, 100~240VAC, 50/60Hz).
Electric power should be off when DC and AC wires are connected to DC power
supplies.
6) Turn on electric power and check all modules for illumination. Review all
inatallation steps above if F-LED 125 fails to light.
Caution :
Caution :