VQZ2121-5YZ1-N7T SMC Corporation, VQZ2121-5YZ1-N7T Datasheet - Page 74

• Manufacturer Part Number: VQZ2121-5YZ1-N7T
• Description: Solenoid Valve, 5 port, body ported, 2 position sngl, 24VDC, DIN, 1/4 port
• Manufacturer: SMC Corporation
• Type: Solenoidr

Specifications of VQZ2121-5YZ1-N7T

• Brand/series: VQZ Series
• Configuration: 2-Position Single
• Number Of Ports: 5
• Primary Type: Solenoid Valve
• Size, Port: 1⁄4"
• Voltage, Coil: 24 VDC
• Operating Pressure Range: 15-100 PSI (30-100 PSI For Three Position Valves)

1. Body ported (VQZ 82 , N.C./VQZ 92 , N.O.)
2. Base mounted (VQZ 85 , N.C./VQZ 95 , N.O.)
Back page 5
Even though 3 port valves have the same construction as the
5 port single solenoid valves, the port plug is installed in the
2(B) port for N.C. type, and 4(A) port for N.O. type. By chang-
ing the port plug into a fitting, it can be used as the 5 port sin-
gle solenoid valves, too.
3 port valves have the same external appearance as the 5
port valves. When using this type, 4(A) port on the 3 port
valves can be used as 4(A) port on the 5 port valves’ manifold,
too. Besides, there’s no problem, even though 2(B) port can
be either plugged or unplugged.
When port plug is used on 2 (B) port, indicate CM in manifold
part no. and port size, and specify the port plug location by
the manifold specification sheet.
3 port valve
3 port valve
3 Port Valve for Mixture Mounting
Series
Specific Product Precautions 4
Be sure to read this before handling.
For Safety Instructions and Common Precautions, refer to “Precautions for Handling
Pneumatic Devices” (M-03-E3A).
1
2
3
1
2
3
0
1
0
1
Port plug
VQZ
5 port valve
Port plug
5 port valve
1
2
3
1
2
3
0
1
0
1
The built-in fittings on the manifold can be
changed easily. Simply remove the corre-
sponding valve and take out the fitting clip un-
derneath.
Take out the clip with a screwdriver, etc., then replace the fittings.
About mounting the fittings, after inserting the fitting until it stops,
then put the clip into the prescribed position.
VQZ1000/2000: Horizontally clipped to the valve body
VQZ3000: Vertically clipped to the valve body
Precautions
When pulling the fitting assembly away from the valve base, re-
move the clip, then connect a tube or plug (KQP-„„) with the
one-touch fitting and pull it out holding the tube or plug. Do not
hold the release bushing to avoid damage.
Caution
VQZ3000
One-touch Fittings Replacement
Fitting assembly
Clip
Clip
VQZ1000/2000
Fitting assembly
Fitting assembly
Clip