MAX618EEE Maxim Integrated Products, MAX618EEE Datasheet - Page 6

• Manufacturer Part Number: MAX618EEE
• Description: DC/DC Switching Controllers 28V PWM Step-Up DC/DC Converter
• Manufacturer: Maxim Integrated Products

Specifications of MAX618EEE

• Output Voltage: 3.05 V
• Output Current: 200 uA
• Input Voltage: 3 V to 28 V
• Supply Current: 500 uA
• Switching Frequency: 250 KHz
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C

28V, PWM, Step-Up DC-DC Converter
the output capacitor. Output current is limited by the 2A
MOSFET current limit and the MAX618’s package
power-dissipation limit. See the Maximum Output
Current section for details.
In Idle Mode, the MAX618 improves light-load efficien-
cy by reducing inductor current and skipping cycles to
reduce the losses in the internal switch, diode, and
inductor. In this mode, a switching cycle initiates only
when the error comparator senses that the output volt-
age is about to drop out of regulation. When this
occurs, the NMOS switch turns on and remains on until
the inductor current exceeds the nominal 350mA Idle
Mode current limit.
Refer to Table 1 for an estimate of load currents at which
the MAX618 transitions between PWM and Idle Mode.
Although the higher loop gain of voltage-controlled
architectures tends to provide tighter load regulation,
current-controlled architectures are generally easier to
compensate over wide input and output voltage
Figure 2. Functional Diagram
6
_______________________________________________________________________________________
SHDN
GND
SHUTDOWN
Compensation Scheme
COMPENSATION
COMPARATOR
SHUTDOWN
ERROR
SLOPE
THERMAL
IDLE MODE
CURRENT LIMIT
OSCILLATOR
250kHz
REFERENCE
CURRENT LIMIT
PWM
LOGIC
PWM
14R
ranges. The MAX618 uses both control schemes in par-
allel: the dominant, low-frequency components of the
error signal are tightly regulated with a voltage-control
loop, while a current-control loop improves stability at
higher frequencies. Compensation is achieved through
the selection of the output capacitor (C
grator capacitor (C
from FB to GND. C
and its ESR. Refer to the Capacitor Selection section for
guidance on selecting these capacitors.
The MAX618 contains a 3.1V low-dropout linear regula-
tor to power internal circuitry. The regulator’s input is IN
and its output is VL. The IN to VL dropout voltage is
100mV, so that when IN is less than 3.2V, VL is typically
100mV below IN. The MAX618 still operates when the
LDO is in dropout, as long as VL remains above the
2.7V undervoltage lockout. Bypass VL with a 4.7μF
ceramic capacitor placed as close to the VL and GND
pins as possible.
INTEGRATOR
MAX618
R
REGULATOR
VL
LINEAR
CURRENT-
CIRCUIT
SENSE
NMOS
COMP
P
cancels the zero formed by C
VL Low-Dropout Regulator
), and the pole capacitor (C
PGND
FB
COMP
VL
LX
IN
IN
OUT
), the inte-
OUT
OUT
P
)