DC-ME-01T-C-50 Digi International, DC-ME-01T-C-50 Datasheet - Page 13

• Manufacturer Part Number: DC-ME-01T-C-50
• Description: ME 8MB SDRAM 2MB FLASH 50 PAK
• Manufacturer: Digi International

Specifications of DC-ME-01T-C-50

• Module/board Type: Device Server
• For Use With/related Products: Networking
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Connectors: Ethernet Interface
A b o u t t h e D i g i C o n n e c t M E & D i g i C o n n e c t W i - M E E m b e d d e d M o d u l e s
Note
The Ethernet connector is an 8-wire RJ-45 jack that meets the ISO 8877 requirements for
10/100BASE-T. See the following figure and table for pin orientation and pin assignments.
Note
The development board provides a reference design of a POE (Power Over
Pin orientation and assignments are the same for modules with or without a
Ethernet) power supply. A schematic for this reference design is installed by
the setup program on the CD.
JTAG connector.
Power and Device Interface Connector Pin Assignments
17-19
Pin
11
12
13
14
15
16
20
CTS / GPIO 2
DSR / GPIO 3
DCD / GPIO 1
RESET
+3.3V
GND
—
/INIT
Signal
Digi Connect Wi-ME
Clear to Send (Input) / GPIO
Data Set Ready (Input) / GPIO
Data Carrier Detect (Input) / GPIO
Reset
Power
Ground
Reserved. Do not connect.
Software Reset
Description
5