20-101-0732 Rabbit Semiconductor, 20-101-0732 Datasheet - Page 86

• Manufacturer Part Number: 20-101-0732
• Description: INTERFACE SMART SCREEN OP7100
• Manufacturer: Rabbit Semiconductor

Specifications of 20-101-0732

• Module/board Type: Single Board Computer Module
• For Use With/related Products: OP7100
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 20-101-732; 20-101-732

Mounting
A bezel and a gasket are included with the OP7100. When properly mount-
ed in a panel, the bezel of the OP7100 is designed to meet NEMA 4 speci-
fications for water resistance.
Since the OP7100 employs an LCD display, the viewing angle must be
considered when mounting the display. Install the OP7100 at a height and
angle that makes it easy for the operator to see the screen.
Bezel-Mount Installation
This section describes and illustrates how to bezel-mount the OP7100.
Follow these steps for bezel-mount installation.
1. Cut mounting holes in the mounting panel in accordance with the
2. Remove all eight 4-40 locking hex nuts from their studs on the bezel,
86
0.180
(4.5)
recommended dimensions in Figure 6-2, then use the bezel faceplate to
mount the OP7100 onto the panel.
and carefully “drop in” the OP7100 with the bezel and gasket attached.
Installation
0.125 D, 8x
(3)
1.620
(40)
Note that the contrast controls, both manual and software, act
as view-angle controls, and should be adjusted to provide
theoptimum display quality at the angle from which the display
will normally be viewed.
Figure 6-2. Recommended Cutout Dimensions
5.380
(137)
CUTOUT
7.000
(178)
OP7100