101-0303 Rabbit Semiconductor, 101-0303 Datasheet - Page 18

• Manufacturer Part Number: 101-0303
• Description: SMARTSCREEN OP7100 DISPLAY
• Manufacturer: Rabbit Semiconductor

Specifications of 101-0303

• Module/board Type: Single Board Computer Module with display
• For Use With/related Products: Single Board Computers
• Lead Free Status / RoHS Status: Vendor undefined / Vendor undefined

Initial OP7100 Setup
Parts Required
•
•
The necessary parts are supplied with the Tool Kit.
Setting Up the OP7100
1. Remove the green power connector shown in Figure 2-1 from the back
2. Attach the bare leads from the power supply to the terminals on the
3. Plug the connector back into the power connection header at the back
4. Plug the power supply into a wall outlet. The display should now light up
18 Getting Started
24 V unregulated DC power supply capable of delivering up to 1.1 A
Serial cable
of the OP7100.
power connector as shown in Figure 2-1.
of the OP7100. Watch the polarity of the connection so that the banded
wire from the power supply goes to DCIN as shown in Figure 2-1.
with the demonstration screens shown in Figure 2-2.
Be careful to connect the power supply wires to the correct
screw terminals on header J8. The OP7100 may be destroyed
if the power supply is connected to the wrong screw terminal.
A protective diode prevents damage to the OP7100 if the
power supply polarity is reversed.
Figure 2-1. OP7100 Power Supply Connections
OP7100