CPE-223 CUI Inc, CPE-223 Datasheet - Page 3
![BUZZER PIEZO 12VDC 3.3KHZ PCB](/photos/0/3/309/mfg_cpe-223_sml.jpg)
CPE-223
Manufacturer Part Number
CPE-223
Description
BUZZER PIEZO 12VDC 3.3KHZ PCB
Manufacturer
CUI Inc
Series
CPEr
Type
Piezo Indicator, Internal Driver
Datasheet
1.CPE-223.pdf
(5 pages)
Specifications of CPE-223
Frequency
3.3kHz
Voltage - Rated
12VDC
Current Rating
13mA
Size / Dimension
Circular - 23.8mm Dia x 12.2mm H
Mounting Type
Through Hole
Sound Pressure Level
81dB
Operating Mode
Continuous
Voltage Range
3 ~ 20VDC
Termination
Solder Pins/Posts
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Capacitance @ Frequency
-
Other names
102-1625
PART NUMBER: CPE-223
MECHANICAL CHARACTERISTICS
item
solderability
soldering heat resistance
terminal strength pulling
vibration
drop test
ENVIRONMENT TEST
item
high temp. test
low temp. test
humidity test
temp. cycle test
20050 SW 112
th
Ave. Tualatin, Oregon 97062
test condition
Lead terminals are immersed in rosin for
5 seconds and then immersed in solder bath
of 270 ±5°C for 3 ±1 seconds.
Lead terminals are immersed up to 1.5mm from
buzzer’s body in solder bath of 300 ±5°C for
3 ±0.5 seconds or 260 ±5°C for 10 ±1 seconds.
For 10 seconds, the force of 300g is
applied to each terminal in axial direction.
The buzzer shall be measured after applying
a vibration amplitude of 1.5 mm with 10 to
55 Hz band of vibration frequency to each of
the 3 perpendicular directions for 2 hours.
The part will be dropped from a height of
75 cm onto a 40 mm thick wooden board 3
times in 3 axes (X, Y, Z) for a total of 9 drops.
test condition
After being placed in a chamber at +95°C for
240 hours.
After being placed in a chamber at -30°C for
240 hours.
After being placed in a chamber at +40°C and
90±5% relative humidity for 240 hours.
The part shall be subjected to 5 cycles. One
cycle will consist of:
-30
0.5hr 0.5hr 0.25 0.5hr
+25
phone
phone 503.612.2300 fax
3hours
DESCRIPTION: piezo audio indicators
+95
0.5hr
0.5hr 0.25
+25
fax 503.612.2383
evaluation standard
evaluation standard
No damage or cutting off.
The buzzer will be measured after
90% min. of the lead terminals
will be wet with solder
(except the edge of the terminal).
No interference in operation.
The value of oscillation
frequency/current consumption
should be ±10% of the initial
measurements. The SPL should
be within ±10dB compared with
the initial measurement.
being placed at +25°C for 4
hours. The value of the
oscillation frequency/current
consumption should be ±10%
compared to the initial
measurements. The SPL should
be within ±10dB compared to the
initial measurements.
page
date
11/12/2007
3 of 5