JKXER0G07FPSDPR Souriau Connection Technology, JKXER0G07FPSDPR Datasheet - Page 2

• Manufacturer Part Number: JKXER0G07FPSDPR
• Description: Circular Push Pull Connectors PUSH-PULL REAR MNT
• Manufacturer: Souriau Connection Technology
• Series: JKXr

Specifications of JKXER0G07FPSDPR

• Product Type: Connectors
• Number Of Contacts: 7
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Turret with locator for pin and socket 1.6 mm and 2 mm contacts
Crimping Tool
Locator Pin and Socket .07-.09 mm and 1.3 mm contacts
Rev 1 – April 14, 2004
5. If inserting terminated contacts:
b. If using clipped solder contacts, prep each wire with flux and then tin dip each
a. Starting with the interface end of the contact, insert each contact into the backside
exposed wire end. Next pre-load a piece of heat shrink onto the wire (Individual
heat shrink tubes are optional). Solder each wire to the solder cup end of the
contact. To avoid shorts, make sure that no solder comes in contact with any other
contact or wire on the connector. After the contact has been soldered to the wire,
check each contact to insure that the contact is securely soldered to the wire. Slide
the pre-loaded heat shrink over the solder joint and shrink into place. Do not over-
heat the solder joint area as it can cause the solder to re-flow or it could burn the
wire insulation.
of the insulator that has the position loading path indicator (worm) on it. Start
with the end of the position loading path indicator (worm) that has the half circle
on it (Position #1). Then follow the position loading path indicator (worm) around
the insulator. You will go counter clockwise if using a male contact and clockwise
if using a female contact (see diagram below for the position loading path
indicator (worm) layout). If the connector has center contacts, it is sometimes
easier to start at the end of the position loading path indicator (worm) (last
position) and work backwards. This is up to the assembler and the process used to