EPF8636ALC84-4 Altera, EPF8636ALC84-4 Datasheet - Page 13

• Manufacturer Part Number: EPF8636ALC84-4
• Description: IC FLEX 8000 FPGA 6K 84-PLCC
• Manufacturer: Altera
• Series: FLEX 8000r

Specifications of EPF8636ALC84-4

• Number Of Logic Elements/cells: 504
• Number Of Labs/clbs: 63
• Number Of I /o: 68
• Number Of Gates: 6000
• Voltage - Supply: 4.75 V ~ 5.25 V
• Mounting Type: Surface Mount
• Operating Temperature: 0°C ~ 85°C
• Package / Case: 84-PLCC
• Family Name: FLEX 8000
• Number Of Usable Gates: 6000
• Number Of Logic Blocks/elements: 504
• # Registers: 636
• # I/os (max): 68
• Frequency (max): 125MHz
• Process Technology: CMOS
• Operating Supply Voltage (typ): 5V
• Logic Cells: 504
• Ram Bits: 8
• Device System Gates: 6000
• Operating Supply Voltage (min): 4.75V
• Operating Supply Voltage (max): 5.25V
• Operating Temp Range: 0C to 70C
• Operating Temperature Classification: Commercial
• Mounting: Surface Mount
• Pin Count: 84
• Package Type: PLCC
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Total Ram Bits: -
• Lead Free Status / Rohs Status: Not Compliant
• Other names: 544-1958; EPF8636ALC84-4; Q2363525

Altera Corporation
Internal Tri-State Emulation
Internal tri-state emulation provides internal tri-stating without the
limitations of a physical tri-state bus. In a physical tri-state bus, the
tri-state buffers’ output enable signals select the signal that drives the bus.
However, if multiple output enable signals are active, contending signals
can be driven onto the bus. Conversely, if no output enable signals are
active, the bus will float. Internal tri-state emulation resolves contending
tri-state buffers to a low value and floating buses to a high value, thereby
eliminating these problems. The MAX+PLUS II software automatically
implements tri-state bus functionality with a multiplexer.
Clear & Preset Logic Control
Logic for the programmable register’s clear and preset functions is
controlled by the DATA3, LABCTRL1, and LABCTRL2 inputs to the LE. The
clear and preset control structure of the LE is used to asynchronously load
signals into a register. The register can be set up so that LABCTRL1
implements an asynchronous load. The data to be loaded is driven to
DATA3; when LABCTRL1 is asserted, DATA3 is loaded into the register.
During compilation, the MAX+PLUS II Compiler automatically selects
the best control signal implementation. Because the clear and preset
functions are active-low, the Compiler automatically assigns a logic high
to an unused clear or preset.
The clear and preset logic is implemented in one of the following six
asynchronous modes, which are chosen during design entry. LPM
functions that use registers will automatically use the correct
asynchronous mode. See
Clear only
Preset only
Clear and preset
Load with clear
Load with preset
Load without clear or preset
FLEX 8000 Programmable Logic Device Family Data Sheet
Figure
7.
13
3