EPM7128SQC160-15N Altera, EPM7128SQC160-15N Datasheet - Page 17

• Manufacturer Part Number: EPM7128SQC160-15N
• Description: IC MAX 7000 CPLD 128 160-PQFP
• Manufacturer: Altera
• Series: MAX® 7000r

Specifications of EPM7128SQC160-15N

• Programmable Type: In System Programmable
• Delay Time Tpd(1) Max: 15.0ns
• Voltage Supply - Internal: 4.75 V ~ 5.25 V
• Number Of Logic Elements/blocks: 8
• Number Of Macrocells: 128
• Number Of Gates: 2500
• Number Of I /o: 100
• Operating Temperature: 0°C ~ 70°C
• Mounting Type: Surface Mount
• Package / Case: 160-MQFP, 160-PQFP
• Voltage: 5V
• Memory Type: EEPROM
• Number Of Logic Elements/cells: 8
• Cpld Type: EEPROM
• No. Of Macrocells: 128
• No. Of I/o's: 100
• Propagation Delay: 15ns
• Global Clock Setup Time: 11ns
• Frequency: 76.9MHz
• Supply Voltage Range: 4.75V To 5.25V
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Other names: 544-2043; EPM7128SQC160-15N

Altera Corporation
f
For more information on using the Jam language, refer to AN 122: Using
Jam STAPL for ISP & ICR via an Embedded Processor.
The ISP circuitry in MAX 7000S devices is compatible with IEEE Std. 1532
specification. The IEEE Std. 1532 is a standard developed to allow
concurrent ISP between multiple PLD vendors.
Programming Sequence
During in-system programming, instructions, addresses, and data are
shifted into the MAX 7000S device through the TDI input pin. Data is
shifted out through the TDO output pin and compared against the
expected data.
Programming a pattern into the device requires the following six ISP
stages. A stand-alone verification of a programmed pattern involves only
stages 1, 2, 5, and 6.
1.
2.
3.
4.
5.
6.
Enter ISP. The enter ISP stage ensures that the I/O pins transition
smoothly from user mode to ISP mode. The enter ISP stage requires
1 ms.
Check ID. Before any program or verify process, the silicon ID is
checked. The time required to read this silicon ID is relatively small
compared to the overall programming time.
Bulk Erase. Erasing the device in-system involves shifting in the
instructions to erase the device and applying one erase pulse of
100 ms.
Program. Programming the device in-system involves shifting in the
address and data and then applying the programming pulse to
program the EEPROM cells. This process is repeated for each
EEPROM address.
Verify. Verifying an Altera device in-system involves shifting in
addresses, applying the read pulse to verify the EEPROM cells, and
shifting out the data for comparison. This process is repeated for
each EEPROM address.
Exit ISP. An exit ISP stage ensures that the I/O pins transition
smoothly from ISP mode to user mode. The exit ISP stage requires
1 ms.
MAX 7000 Programmable Logic Device Family Data Sheet
17