MT29F1G08ABBDAHC-IT:D Micron Technology Inc, MT29F1G08ABBDAHC-IT:D Datasheet - Page 35

• Manufacturer Part Number: MT29F1G08ABBDAHC-IT:D
• Description: MICMT29F1G08ABBDAHC-IT:D 1GB SLC NAND 34
• Manufacturer: Micron Technology Inc

Specifications of MT29F1G08ABBDAHC-IT:D

• Lead Free Status / Rohs Status: Supplier Unconfirmed

READ PARAMETER PAGE (ECh)
Figure 26: READ PARAMETER (ECh) Operation
PDF: 09005aef83e5ffed
m68a.pdf – Rev. D 06/10 EN
Cycle type
I/O[7:0]
R/B#
Command
ECh
The READ PARAMETER PAGE (ECh) command is used to read the ONFI parameter
page programmed into the target. This command is accepted by the target only when
all die (LUNs) on the target are idle.
Writing ECh to the command register puts the target in read parameter page mode. The
target stays in this mode until another valid command is issued.
When the ECh command is followed by an 00h address cycle, the target goes busy for
t
the READ MODE (00h) command must be used to re-enable data output mode.
A minimum of three copies of the parameter page are stored in the device. Each param-
eter page is 256 bytes. If desired, the RANDOM DATA READ (05h-E0h) command can be
used to change the location of data output.
R. If the READ STATUS (70h) command is used to monitor for command completion,
Address
00h
t WB
t R
t RR
35
D
P0
OUT
0
Micron Technology, Inc. reserves the right to change products or specifications without notice.
D
P1
1Gb x8, x16: NAND Flash Memory
OUT
0
READ PARAMETER PAGE (ECh)
D
…
OUT
D
P0
OUT
1
© 2010 Micron Technology, Inc. All rights reserved.
D
P1
OUT
1
D
…
OUT