DEHR33D102KA3B Murata Electronics, DEHR33D102KA3B Datasheet - Page 28

• Manufacturer Part Number: DEHR33D102KA3B
• Description: Cap Ceramic 0.001uF 2000VDC R 10% 12 X 5mm RDL 7.5mm Bulk
• Manufacturer: Murata Electronics
• Type: Radialr

Specifications of DEHR33D102KA3B

• Package/case: 12(Max) X 5(Max)
• Lead Pitch For Radial: 7.5 mm
• Capacitance Value: 0.001 uF
• Dielectric: R
• Tolerance: 10 %
• Voltage: 2000 Vdc
• Product Depth: 5(Max) mm

5
!Note
• This PDF catalog is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’s specifications are subject to change or our products in it may be discontinued without advance notice. Please check with our
• This PDF catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
sales representatives or product engineers before ordering.
!Note
4. Fail-Safe
FAILURE TO FOLLOW THE ABOVE CAUTIONS MAY
RESULT, WORST CASE, IN A SHORT CIRCUIT
AND CAUSE FUMING OR PARTIAL DISPERSION
WHEN THE PRODUCT IS USED.
26
(2) Voltage Applied Method
Safety Certified Ceramic Capacitors !Caution
When the withstanding voltage is applied, capacitor's
lead or terminal should be firmly connected to the output
of the withstanding voltage test equipment, and then the
voltage should be raised from near zero to the test
voltage.
If the test voltage without the raise from near zero voltage
would be applied directly to capacitor, test voltage should
be applied with the zero cross*. At the end of the test
time, the test voltage should be reduced to near zero,
and then capacitor's lead or terminal should be taken off
the output of the withstanding voltage test equipment.
If the test voltage without the raise from near zero voltage
would be applied directly to capacitor, the surge voltage
may arise, and therefore, a defect may be caused.
*ZERO CROSS is the point where voltage sine wave
When capacitor is broken, failure may result in a short
circuit. Be sure to provide an appropriate fail-safe
function like a fuse on your product if failure could result
in an electric shock, fire or fuming.
Continued from the preceding page.
passes 0V. See figure at right.
• Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
0V
Voltage sine wave
zero cross
C85E.pdf
08.10.29