LQ121S1LG41 Sharp Electronics, LQ121S1LG41 Datasheet - Page 16

• Manufacturer Part Number: LQ121S1LG41
• Manufacturer: Sharp Electronics

Specifications of LQ121S1LG41

• Size: 12.1in
• Resolution Term: SVGA-Strong 1
• Resolution: 800 x 600Pixels
• Nits: 370
• Contrast Ratio: 300
• Viewing Angle (up/down),(right/left): 60/50 , 70/70deg
• Operating Temperature: -10 to +65deg C
• Backlight: 1 x CCFT
• Panel Mode: Transmissive
• Interface: LVDS
• Lead Free Status / Rohs Status: Compliant

11. Display Quality
12.Handling Precautions
13. Packing form
l) Connect GND to 4 place of mounting holes to stabilize against EMI and external noise.
m) There are high voltage portions on the backlight and very dangerous. Careless touch may lead to
a) Be sure to turn off the power supply when inserting or disconnecting the cable.
b) Be sure to design the cabinet so that the module can be installed without any extra stress such as
c) Since the front polarizer is easily damaged, pay attention not to scratch it.
d) Wipe off water drop immediately. Long contact with water may cause discoloration or spots.
e) When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth.
f) Since the panel is made of glass, it may break or crack if dropped or bumped on hard surface.
g) Since CMOS LSI is used in this module, take care of static electricity and injure the human earth
h) Since there is a circuit board in the module back, stress is not added at the time of a design assembly.
i) Protection film is attached to the module surface to prevent it from being scratched .
j) The polarizer surface on the panel is treated with Anti-Glare for low reflection. In case of attaching
k) Do not expose the LCD panel to direct sunlight. Lightproof shade etc. should be attached when LCD
n) When handling LCD modules and assembling them into cabinets, please be noted that long-term
o) Cold cathode fluorescent lamp in LCD panel contains a small amount of mercury, please follow local
p) Be careful of a back light lead not to pull by force at the time of the wiring to an inverter,
q) When install LCD modules in the cabinet, please tighten with “torque=0.294 0.02N m(3.0 0.2kgf cm)”.
Inspection Standard.
The display quality of the color TFT-LCD module shall be in compliance with the Incoming
warp or twist.
Handle with care.
Please make it like. If stress is added, there is a possibility that circuit parts may be damaged.
Peel the film off slowly , just before the use, with strict attention to electrostatic charges.
Blow off 'dust' on the polarizer by using an ionized nitrogen.
protective board over the LCD, be careful about the optical interface fringe etc. which degrades
display quality.
panel is used under such environmentl
storage in the environment of oxidization or deoxidization gas and the use of such materials as
reagent,solvent, adhesive, resin, etc. which generate these gasses, may cause corrosion and
discoloration of the LCD modules.
ordinances or regulations for disposal.
or line processing.
electrical shock. When exchange lamps or service, turn off the power without tail.
Product country
Piling number of cartons
Package quantity in one carton
Carton size
Total mass of one carton filled
Packing form is shown
when handling.Observe all other precautionary requirements in handling components.
with full modules
JAPAN
395
(W)× 275 (H)× 350 (D) mm
TAIWAN
MAX. 5
10pcs
8000
Fig.2
g
CHINA
LD15606C-