LQ058T5DRQ1 Sharp Electronics, LQ058T5DRQ1 Datasheet - Page 16

• Manufacturer Part Number: LQ058T5DRQ1
• Manufacturer: Sharp Electronics

Specifications of LQ058T5DRQ1

• Lead Free Status / Rohs Status: Compliant

sharp
(11) Display quality
(12) Handling instructions
12-1) Mounting of module
12-2) Precautions in mounting
B)I/O connector of backlight driving circuit 【JST】
a). The noise from the backlight unit will increase.
b). The output from inverter circuit will be unstable. Then, there may be a possibility that
c). In some cases, a part of module will heat.
It is recommended to peel off the laminator immediately before the use, taking care of static
electricity.
four corners of the module at the rear side.
recommended, be sure to fix the module on the same plane, taking care not to wrap or twist the
module.
may be disturbed.
circuit surely. If that connection is not perfect, there may be a possibility that the following
problems happen.
Lump connector
Inspection Standards for TFT-LCD.
On mounting the module, as the M2.6 tapping screw fastening torque is 0.3 through 0.5N･m is
Don't reach the pressure of touch-switches of the set side to a module directly, because images
Please power off the module when you connect the input/output connector.
Please connect the metallic shielding cases of the module and the ground pattern of the inverter
Protective film (Laminator) is applied on the surface to protect it against scratches and dirties.
Precautions in peeling off the laminator
The TFT-LCD module is designed to be mounted on equipment using the mounting tabs in the
Polarizer which is made of soft material and susceptible to flaw must be handled carefully.
The display quality of the color TFT-LCD module shall be in compliance with the Incoming
some problems happen.
Symbol
CNA,B
A) Working environment
When the laminator is peeled off, static electricity may cause dust to stick to the polarizer
surface. To avoid this, the following working environment is desirable.
a) Floor: Conductive treatment of 1MΩ or more on the tile
Used Connector
BHR-02(8.0)VS-1N
(conductive mat or conductive paint on the tile)
Corresponding connector
SM02(8.0)B-BHS-1N(assembled on PWB)
SM02(8.0)B-BHS-TB(assembled on PWB)
BHMR-03V (interconnecter)
LCY01023−13