LQ035Q7DB05 Sharp Electronics, LQ035Q7DB05 Datasheet - Page 19

• Manufacturer Part Number: LQ035Q7DB05
• Manufacturer: Sharp Electronics

Specifications of LQ035Q7DB05

• Lead Free Status / Rohs Status: Compliant

[Note 9-4] A measurement device is Minolta CM-2002.
[Note 9-5] Definition of reflection ratio
[Note 9-6] A measurement device is ELDIM EZContrast
[Note 9-7] This is the reference value. The White-LED life time is defind as a time when brightness not to become
(10) Display quality
(11)Mechanical characteristics
(12)Handling Precautions
11-1) External appearance
11-2) FPC (for LCD panel) characteristics
12-1) Insertion and taking out of FPCs
12-2) Handling of FPCs
12-3) Installation of the module
12-4)Precaution when mounting
(1) If water droplets and oil attaches to it for a long time, discoloration and staining occurs. Wipe them off
(2) Glass is used for the TFT-LCD panel. If it is dropped or bumped against a hard object, it may be broken.
(3)As the CMOS IC is used in this module, pay attention to static electricity when handling it. Take a
measure for grounding on the human body.
The display quality of the color TFT-LCD module shall be in compliance with
the Incoming Inspection Standards for TFT-LCD.
See Fig. 1
(1)Specific connector
(2) Bending endurance of the bending slits portion
On mounting the module, be sure to fix the module on the same plane. Taking care not to warp or
twist the module.
supply on the set side.
on the whole slit portion with bending radius larger than 0.6mm ,and only inner side (back side
of the module). Don’t bend it outer side (display surface side).
under 50% of the original value(at Ta=25℃)
Be sure insert and take out of the FPC into the connector of the set after turning off the power
Don’t give the FPCs too large force, for example, hanging the module with holding FPC.
immediately.
Handle it with sufficient care.
The FPC for LCD panel shall be bent only slit portion. The bending slit shall be bent uniformly
Reflection ratio =
FH12-50S-0.5SH(55) (HIROSE)
No line of the FPC is broken for the bending test (Bending radius=0.6mm and
angle=90°) in 30 cycles.
Light detected level of the reflection by the standard white board
Light detected level of the reflection by the LCD module
LCP-2506033-16