619135-1 TE Connectivity, 619135-1 Datasheet - Page 10

• Manufacturer Part Number: 619135-1
• Description: RF/COAXIAL, BNC PLUG, STR, 50OHM, SOLDER
• Manufacturer: TE Connectivity

Specifications of 619135-1

• Connector Type: BNC Coaxial
• Body Style: Straight Plug
• Coaxial Termination: Solder
• Impedance: 50ohm
• Contact Material: Phosphor Bronze
• Contact Plating: Gold
• Frequency Max: 6GHz
• Rohs Compliant: Yes
• Type Of Connector: Compression Coax Board-to-Board
• Pcb Mount Style: Surface Mount
• Connector Impedance (?): 50
• Operating Frequency (mhz): 0 – 6,000
• Voltage Rating (vac): 125
• Dielectric Withstanding Voltage (v): 500
• Insulation Resistance (m?): 100
• Length (mm [in]): 6.65 [0.262]
• Mount Type: Printed Circuit Board
• Return Loss (db): -20
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Reflow solder capable to 245°C, Reflow solder capable to 260°C
• Rohs/elv Compliance History: Always was RoHS compliant
• Operating Temperature (°c [°f]): -40 – +125 [-40 – +257]
• Packaging Method: Loose Piece

4.
5.
5.1
5.2
5.3
5.4
Rev E1
QUALIFICATION TEST RESULTS
All requirements were met. Refer to 501-90021, 501-90024 and 501-71011 for detailed
results.
QUALITY ASSURANCE PROVISIONS
Qualification Testing
A.
B.
Requalification Testing
If changes significantly affecting form, fit or function are made to product or
manufacturing process, product assurance shall coordinate requalification testing,
consisting of all or part of original testing sequence as determined by
development/product, quality and reliability engineering.
Acceptance
Acceptance is based on verification that product meets requirements of Figure 1.
Failures attributed to equipment, test setup, customer supplied components or operator
deficiencies shall not disqualify the product. If product failure occurs, corrective action
shall be taken and samples resubmitted for qualification. Testing to confirm corrective
action is required before resubmitting.
Quality Conformance Inspection
The applicable quality inspection plan shall specify the sampling acceptable quality level
to be used.
Dimensional and functional requirements shall be in accordance with applicable product
drawing and this specification.
Specimen Selection
Specimen shall be prepared in accordance with applicable Instruction Sheets and
shall be selected at random from current production.
All test groups shall each consist of a minimum of 10 specimens P/N 619127-1
except test-group 4 for which a minimum of 5 specimens is required, and test-
group 5 for which a minimum of 2 specimens is required.
Test Sequence
Qualification inspection shall be verified by testing specimens as specified in
Figure 6.
108-71060
Page 10 of 10