RD4247MAG3110 Freescale Semiconductor, RD4247MAG3110 Datasheet - Page 2

• Manufacturer Part Number: RD4247MAG3110
• Description: DEV KIT MAG3110 LFSTBUSB
• Manufacturer: Freescale Semiconductor
• Series: -r

Specifications of RD4247MAG3110

• Sensor Type: Accelerometer, 3 Axis
• Sensing Range: ±10g
• Interface: I²C
• Sensitivity: 1mg/bit
• Voltage - Supply: 1.95 V ~ 3.6 V
• Embedded: No
• Utilized Ic / Part: MAG3110
• Features: LFSTBUSB For Communication To PC, MAG3110FC & MMA8451Q For System Calibration
• Peak Reflow Compatible (260 C): Yes
• Rohs Compliant: Yes
• Application Sub Type: Magnetic Sensor
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Getting Started
2
To begin using the kit, assemble the kit’s hardware and install the sensor toolbox software on the
Windows
2.1
As instructed in the LFSTBEB3110 Quick Start Guide:
The hardware assembly will be completed as part of the software-installation procedure that follows.
When the kit is assembled, its compass-pointing direction is indicated by the red arrow in the preceding
illustration. This direction ergonomically facilitates the evaluation of the eCompass functionality as the
board assembly can be held by its USB connector.
2.2
The free sensor toolbox software provides an eCompass application with hard- and soft-iron calibration
algorithms.
At the end of the installation process, you will be asked about installing a Future Technology Devices
International (FTDI) serial-to-USB communications driver. This driver is required for communication
between the PC and the evaluation board. If you have previously installed the sensor toolbox software, this
driver already is installed.
The kit’s navigation application uses a Google Maps™ demonstration powered by the Adobe
Shockwave
at the end of the procedure.
2
1. Attach the two LFSTBEB3110 boards to the LFSTBUSB USB-interface board.
2. The two LFSTBEB3110 boards are supplied connected. If they become separated, reconnect them,
LFSTBEB3110 adapter board
LFSTBUSB USB-interface board
LFSTBEB3110 sensor board with
MAG3110 and MMA8451Q
aligning the Pin-1 white arrows on both boards.
®
Getting Started
Assembling the Kit
Installing the Sensor Toolbox Software
®
PC to which the kit will be connected.
RD4247MAG3110 Sensor Toolbox Tilt-Compensated eCompass Kit User’s Guide, Rev. 2
software. If the free Shockwave software is not installed on your PC, follow the instructions
LFSTBEB3110
LFSTBUSB
Freescale Semiconductor
®