5406562-2 TE Connectivity, 5406562-2 Datasheet - Page 3

• Manufacturer Part Number: 5406562-2
• Description: MJ,2PORT,8P,SHLD,PNL GRD,CAT4
• Manufacturer: TE Connectivity

Specifications of 5406562-2

• Product Type: Connector
• Jack Type: RJ45
• Pcb Mounting Orientation: Side Entry (Right Angle)
• Pcb Mount Style: Through Hole
• Termination Method To Pc Board: Solder
• Performance Category: Cat 4
• Number Of Contacts Loaded: 8
• Grounding Options: Panel Ground and PCB Ground
• Panel Stops: Without
• Keyed: No
• Profile: Standard
• Color: Black
• Shield Material: Copper Zinc Alloy
• Jack Configuration: 1 x 2
• Panel Mount Retention: Without
• Shielded: Yes
• Solder Tail Contact Plating: Tin over Nickel
• Port Configuration: Multiple
• Number Of Positions: 8
• Inverted Jack Face: No
• Led: Without
• Shield Plating: Tin over Copper
• Number Of Pcb Ground Tabs: 3
• Pcb Tail Length (mm [in]): 3.56 [0.140]
• Number Of Contacts Loaded, Rj45 (8 Positions): 8
• Pcb Ground Tab Location (mm [in]): 4.57 [0.180]
• Preloaded: Yes
• Contact Plating, Mating Area, Material: Gold (50)
• Contact Base Material: Phosphor Bronze
• Number Of Panel Ground Tabs: 9
• Housing Material: High Temperature Nylon
• Ul Flammability Rating: UL 94V-0
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Wave solder capable to 240°C, Wave solder capable to 260°C, Wave solder capable to 265°C
• Rohs/elv Compliance History: Always was RoHS compliant
• Packaging Method: Tray
• Packaging Quantity: 45

4.
4.1.
4.2.
4.3.
4.4.
Rev C
QUALITY ASSURANCE PROVISIONS
Qualification Testing
A.
B.
Requalification Testing
If changes significantly affecting form, fit or function are made to the product or manufacturing process,
product assurance shall coordinate requalification testing, consisting of all or part of the original testing
sequence as determined by development/product, quality and reliability engineering.
Acceptance
Acceptance is based on verification that the product meets the requirements of Figure 1. Failures
attributed to equipment, test setup or operator deficiencies shall not disqualify the product. When
product failure occurs, corrective action shall be taken and samples resubmitted for qualification.
Testing to confirm corrective action is required before resubmittal.
Quality Conformance Inspection
The applicable quality inspection plan will specify the sampling acceptable quality level to be used.
Dimensional and functional requirements shall be in accordance with the applicable product drawing
and this specification.
Sample Selection
Samples shall be prepared in accordance with applicable Instruction Sheets and shall be selected
at random from current production. Test group 1 shall consist of 10 terminated plugs/unmounted
jack pairs.
Test Sequence
Qualification inspection shall be verified by testing samples as specified in Figure 2.
108-1163-2
3 of 4