4-1601000-1 TE Connectivity, 4-1601000-1 Datasheet - Page 4

• Manufacturer Part Number: 4-1601000-1
• Description: 031-001-000=WIRE2WIRE,STD,SMZ
• Manufacturer: TE Connectivity
• Series: SIAMEZEr

Specifications of 4-1601000-1

• Rohs Compliant: YES
• Contact Material: Brass
• Insulator Material: Non-Insulated
• Svhc: No SVHC (15-Dec-2010)
• Wire Size Range (awg): 22-18
• Product: Magnet Wire Terminals
• Wire Size (awg): 34-18
• Insulation: Not Insulated
• Gender: Female
• Termination Style: Wire
• Length: 7.62 mm
• Maximum Bundle Diameter: 1.02 mm
• Mounting Angle: Right
• Mounting Method: Wire
• Number Of Positions / Contacts: 1
• Number Of Rows: 1
• Product Type: Terminal
• Terminal Configuration: Wire-to-Wire
• Specials: Standard
• Magnet Wire Range (mm [awg]): 0.16 – 1.02 [18 – 34]
• Lead Wire Range (mm² [awg]): 0.30 – 0.80 [18 – 22]
• Plating Material: Unplated
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Not relevant for lead free process
• Rohs/elv Compliance History: Always was RoHS compliant
• Packaging Method: Loose Piece
• Lead Free Status / Rohs Status: Details

4.
4.1.
4.2.
4.3.
4.4.
Rev B
QUALITY ASSURANCE PROVISIONS
Qualification Testing
A.
B.
Requalification Testing
If changes significantly affecting form , fit or function are m ade to the product or m anufacturing process,
product assurance shall coordinate requalification testing, consisting of all or part of the original testing
sequence as determ ined by developm ent/product, quality and reliability engineering.
Acceptance
Acceptance is based on verification that the product m eets the requirem ents of Figure 1. Failures
attributed to equipm ent, test setup or operator deficiencies shall not disqualify the product. If product
failure occurs, corrective action shall be taken and specim ens resubm itted for qualification. Testing to
confirm corrective action is required before resubm ittal.
Quality Conform ance Inspection
The applicable quality inspection plan shall specify the sam pling acceptable quality level to be used.
Dim ensional and functional requirem ents shall be in accordance with the applicable product drawing
and this specification.
Specim en Selection
Specim ens shall be prepared in accordance with applicable Instruction Sheets and shall be
selected at random from current production. Each test group shall consist of 30 term inals (15
interconnected bobbin assem blies) per m agnet wire size.
Test Sequence
Qualification inspection shall be verified by testing specim ens as specified in Figure 2.
108-2085
4 of 5