LTC1860IMS8 Linear Technology, LTC1860IMS8 Datasheet - Page 13

• Manufacturer Part Number: LTC1860IMS8
• Description: IC A/D CONV 1CH 12BIT 8-MSOP
• Manufacturer: Linear Technology

Specifications of LTC1860IMS8

• Number Of Bits: 12
• Sampling Rate (per Second): 250k
• Data Interface: MICROWIRE™, Serial, SPI™
• Number Of Converters: 1
• Power Dissipation (max): 1.25mW
• Voltage Supply Source: Single Supply
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 8-TSSOP, 8-MSOP (0.118", 3.00mm Width)
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

APPLICATIONS INFORMATION
Reference Input
The reference input of the LTC1861 SO-8 package is
internally tied to V
therefore equal to V
of the LTC1861 MSOP package defi nes the span of the A/D
converter. The LTC1861 MSOP package can operate with
reference voltages from 1V to V
GENERAL ANALOG CONSIDERATIONS
Grounding
The LTC1860/LTC1861 should be used with an analog
ground plane and single point grounding techniques. Do not
use wire wrapping techniques to breadboard and evaluate
the device. To achieve the optimum performance, use a
printed circuit board. The ground pins (AGND and DGND
for the LTC1861 MSOP package and GND for the LTC1860
and LTC1861 SO-8 package) should be tied directly to the
analog ground plane with minimum lead length.
CC
CC
. The span of the A/D converter is
. The voltage on the reference input
CC
.
Bypassing
For good performance, the V
of noise and ripple. Any changes in the V
with respect to ground during the conversion cycle can
induce errors or noise in the output code. Bypass the V
and V
a minimum of 1μF tantalum. Keep the bypass capacitor
leads as short as possible.
Analog Inputs
Because of the capacitive redistribution A/D conversion
techniques used, the analog inputs of the LTC1860/LTC1861
have capacitive switching input current spikes. These cur-
rent spikes settle quickly and do not cause a problem if
source resistances are less than 200Ω or high speed op
amps are used (e.g., the LT
LT1630, LT1226 or LT1215). But if large source resistances
are used, or if slow settling op amps drive the inputs, take
care to ensure the transients caused by the current spikes
settle completely before the conversion begins.
REF
pins directly to the analog ground plane with
LTC1860/LTC1861
®
1211, LT1469, LT1807, LT1810,
CC
and V
REF
pins must be free
CC
/V
REF
13
voltage
18601fa
CC