208714-2 TE Connectivity, 208714-2 Datasheet - Page 4

• Manufacturer Part Number: 208714-2
• Description: CMC PLUG ASSEMBLY,SZ 14-7
• Manufacturer: TE Connectivity

Specifications of 208714-2

• Rohs Compliant: YES
• Connector Type: Housing
• Mount: Free Hanging
• Mount Angle: Straight
• Shell Size: 14
• Shell Type: Metal
• Product Series: Series 1
• Thread Size: 7/8 - 20 UNEF-2A
• Sealed: Yes
• Mating Retention Type: Threaded Coupling
• Vde Tested: No
• Seal Type: Tetraseal
• Number Of Positions: 7
• Number Of Signal Positions: 7
• Contact Type: Socket
• Reverse Gender: Standard
• Connector Style: Plug
• Mating Alignment Type: Keyed
• Housing Material: Thermoplastic - GF
• Housing Color: Black
• Ul Flammability Rating: UL 94V-0
• Environmental Protection: With
• Reverse Numbering: Without
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Not relevant for lead free process
• Rohs/elv Compliance History: Always was RoHS compliant
• Fluid Resistance: Immersion
• Accepts Wire Insulation Diameter, Range (mm [in]): 2.54 [0.100]

Water Splashing
(a)
(b)
(c)
3.6.
Rev A
The continuous current rating for individual contacts cannot be applied directly to the number of
contacts as they are dependent on the thermal and physical properties of the material. System
design shall assure that continuous current rating does not create internal hot spots that exceed the
temperature designated by the connector specification, during steady-state or transient conditions.
Shall remain mated and show no evidence of damage, cracking or chipping.
Probes with spherical ends of .05 inch minimum radius shall be used.
Connector Tests and Sequences
Examination of Product
Termination Resistance, Dry Circuit
Dielectric Withstanding Voltage
Insulation Resistance
Shell Resistance
Vibration
Physical Shock
Contact Retention
Durability
Maintenance Aging
Retention, Plastic/Insert
Torque
Thermal Shock
Humidity-Temperature Cycling
Industrial Mixed Flowing Gas
Temperature Life
Dust Powder (c)
Water Splashing (c)
NOTE
(a) See Para 4.1.A.
(b) Numbers indicate sequence in which tests are performed.
(c) This test for sealed connectors only.
(d) Unless specifically noted, test 20% or minimum of 7 contacts in each
connector for following tests: Termination resistance, insulation resistance,
dielectric withstanding voltage, contact retention and maintenance aging.
Water shall not interfere with
satisfactory operation and shall not
enter cable or accumulate near
cable end.
Figure (end)
Figure 2
1, 9
2, 8
3, 5
1
6
7
4
1, 5
2, 4
Test Sequence (b)
2
3
Test Group (a)
Subject mated connector and cable
mounted on a turn table to water
splashing for a duration of 10
minutes; IEC 144, IP 54.
1, 11
3, 8
10
3
7
6
9
2
4
5
1, 6
2, 5
4
4
3
1, 5
5
4
2
3
108-10040
4 of 7