DS1077LZ-60+ Maxim Integrated Products, DS1077LZ-60+ Datasheet - Page 9
![IC ECONOSCILL 2WIRE 60MHZ 8SOIC](/photos/1/39/13902/8-soic_21-0042b_sml.jpg)
DS1077LZ-60+
Manufacturer Part Number
DS1077LZ-60+
Description
IC ECONOSCILL 2WIRE 60MHZ 8SOIC
Manufacturer
Maxim Integrated Products
Series
EconOscillator™r
Type
Oscillator, Fixed Frequency, Dualr
Datasheet
1.DS1077LZ-40.pdf
(21 pages)
Specifications of DS1077LZ-60+
Frequency
60MHz
Voltage - Supply
2.7 V ~ 3.6 V
Current - Supply
25mA
Operating Temperature
-40°C ~ 85°C
Package / Case
8-SOIC (3.9mm Width)
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Count
-
Figure 2 details how data transfer is accomplished on the 2-wire bus. Depending upon the state of the
R/W bit, two types of data transfer are possible:
1) Data transfer from a master transmitter to a slave receiver. The first byte transmitted by the
2) Data transfer from a slave transmitter to a master receiver. The first byte (the slave address) is
The master device generates all of the serial clock pulses and the START and STOP conditions. A
transfer is ended with a STOP condition or with a repeated START condition. Since a repeated START
condition is also the beginning of the next serial transfer, the bus will not be released.
The DS1077L can operate in the following two modes:
1) Slave receiver mode: Serial data and clock are received through SDA and SCL. After each byte is
2) Slave transmitter mode: The first byte is received and handled as in the slave receiver mode.
SLAVE ADDRESS
A control byte is the first byte received following the START condition from the master device. The
control byte consists of a four-bit control code; for the DS1077L, this is set as 1011 binary for read and
write operations. The next three bits of the control byte are the device select bits (A2, A1, and A0) and
can be written to the EEPROM. They are used by the master device to select which of eight devices are to
be accessed. The select bits are in effect the three least significant bits of the slave address. The last bit of
the control byte (R/
selected, and when set to a zero a write operation is selected. Following the START condition, the
DS1077L monitors the SDA bus checking the device type identifier being transmitted. Upon receiving the
1011 code (changeable with one mask) and appropriate device select bits, the slave device outputs an
acknowledge signal on the SDA line.
master is the slave address. Next, follows a number of data bytes. The slave returns an acknowledge
bit after each received byte.
transmitted by the master. The slave then returns an acknowledge bit. Next, follows a number of data
bytes transmitted by the slave to the master. The master returns an acknowledge bit after all received
bytes other than the last byte. At the end of the last received byte, a ‘not acknowledge’ is returned.
received, an acknowledge bit is transmitted. START and STOP conditions are recognized as the
beginning and end of a serial transfer. Address recognition is performed by hardware after reception
of the slave address and direction bit.
However, in this mode, the direction bit will indicate that the transfer direction is reversed. Serial data
is transmitted on SDA by the DS1077L while the serial clock is input on SCL. START and STOP
conditions are recognized as the beginning and end of a serial transfer.
W
) defines the operation to be performed. When set to a one a read operation is
9 of 21