104479-3 TE Connectivity, 104479-3 Datasheet - Page 5

• Manufacturer Part Number: 104479-3
• Description: SHORT POINT CONT 15 DPLX STMPD
• Manufacturer: TE Connectivity

Specifications of 104479-3

• Rohs Compliant: NO
• Product Type: Contact
• Termination Method To Wire/cable: Crimp
• Wire Insulation Diameter (mm [in]): 0.64 – 1.52 [0.025 – 0.060]
• Connector Series: Short Point
• With Insulation Support: Yes
• Applied Pressure: Standard
• Contact - Rated Current (a): 3
• Voltage Rating (vac): 300
• Termination Resistance (m?): 12
• Insulation Resistance (m?): 5,000
• Dielectric Withstanding Voltage (v): 750
• Crimp Area Plating: Tin-Lead over Nickel
• Wire Range (mm [awg]): 0.20-0.60² [24-20]
• Contact Type: Socket
• Contact Plating, Mating Area, Material: Gold (15)
• Contact Base Material: Copper Alloy C7025
• Rohs/elv Compliance: Not ELV/RoHS compliant
• Lead Free Solder Processes: Not relevant for lead free process
• Approved Standards: UL E28476, CSA LR7189
• Operating Temperature (°c): -65 – +105
• Applies To: Wire/Cable
• Packaging Method: Strip

4.
4.1.
4.2.
4.3.
4.4.
Rev A
QUALITY ASSURANCE PROVISIONS
Qualification Testing
A.
B.
Requalification Testing
If changes significantly affecting form, fit or function are made to product or manufacturing process,
product assurance shall coordinate requalification testing, consisting of all or part of original testing
sequence as determined by development/product, quality and reliability engineering.
Acceptance
Acceptance is based on verification that product meets requirements of Figure 1. Failures attributed to
equipment, test setup or operator deficiencies shall not disqualify product. When product failure occurs,
corrective action shall be taken and samples resubmitted for qualification. Testing to confirm corrective
action is required before resubmittal.
Quality Conformance Inspection
The applicable quality inspection plan will specify sampling acceptable quality level to be used.
Dimensional and functional requirements shall be in accordance with applicable product drawing and
this specification.
Sample Selection
Samples shall be prepared in accordance with applicable Instruction Sheets and shall be selected
at random from current production. All test groups shall each consist of a minimum of 5 connectors
containing at least 30 contacts total with receptacles crimped to wire and an equal amount of posts
of identical plating type and thickness to mate with receptacles. Test group 1 shall consist of
minimum and maximum position size connectors available. All contacts shall be crimped to
appropriate size tin plated stranded copper test conductors in accordance with Application
Specification 114-25038.
Test Sequence
Qualification inspection shall be verified by testing samples as specified in Figure 2.
108-1472
5 of 6