09 47 474 7211 HARTING, 09 47 474 7211 Datasheet - Page 143

• Manufacturer Part Number: 09 47 474 7211
• Description: Ha-Vis Smart Patch Cable CAT.6 Yel. 10m
• Manufacturer: HARTING

Specifications of 09 47 474 7211

• Rohs Compliant: Yes

General information about Plug Connectors
thickness of e.g. 2 mm can be used as this fits in the
mechanical environment.
Standard reflow solder process
For backplanes press-fit termination is the first choice,
however solder termination offers advantages for
module cards. The Plug Connector is mounted to the
can be delivered with a pick-and-place-pad for
automatic assembly.
Another advantage of this mechanically stable
technology is, that the connector can be replaced. This
can avoid the cost of scrapping a module if the mating
interface is damaged during handling.
Cost savings are possible
By offering so many different advantages during the
manufacturing process, the use of HARTING Plug
Connectors also contributes to keeping costs down.
Selective plating increases the cost of producing gold
Mounting direction
The HARTING Plug Connector is available in two
versions. The difference is the mounting direction, i. e.
the side of the AdvancedMC™ module PCB on which
the Plug Connector is assembled.
Basic side
The so called basic side refers to the component side
1 as defined in the AMC.0 specification (pins 1 to 85).
The main components are mounted on the basic side
(sometimes also called top side).
During the manufacturing process, a Plug Connector
that is mounted from the basic side can be soldered
in the same assembly step as the other large
components.
Extended side
The so called extended side refers to the component
side 2 as defined in the AMC.0 specification (pins 86
to 170).
A Plug Connector mounted on the extended side is
“hanging” at the bottom side of the AdvancedMC™
module.
PCB through “pin-in-
hole-reflow”
technology (PIHR).
It can be soldered in
the same production
process
other semi finished
components on the
AdvancedMC™
module. Optionally,
the Plug Connector
as
solder
the
pads. Tight tolerance specifications also cause a large
number of rejects. The beveled PCB edge is another
critical area, because damage can occur to the contact
pads.
A simple board layout with through-holes is sufficient for
the HARTING Plug, and these boards can be produced
inexpensively and with excellent quality control, thus
reducing the number of rejects. Furthermore the cost
of a reject can be high if a defective PCB edge is not
detected until the board is populated with expensive
components. A HARTING Plug on a module can be
replaced easily, reducing scrapping costs.
This picture shows an AdvancedMC™ module with a Plug
Connector mounted on the extended side.
The footprint of a Plug Connector for the basic
side is different than that for the extended side. The
connectors are not interchangeable. Due to advantages
in the assembly of the connector, the basic side version
is preferable.
For an MCH stack, only connectors having the same
mounting direction can be stacked.
Extended side
(Bottom side)
Basic side
(Top side)
143