703DR00101248D2060A Curtis Instruments Inc, 703DR00101248D2060A Datasheet - Page 10

• Manufacturer Part Number: 703DR00101248D2060A
• Description: LCD COUNTER ACDC PNL MNT W/RESET
• Manufacturer: Curtis Instruments Inc
• Series: 703r

Specifications of 703DR00101248D2060A

• Count Rate: 500Hz
• Number Of Digits/alpha: 6
• Input Type: Voltage
• Voltage - Supply: 12 V ~ 48 V
• Display Type: LCD Non-Backlit
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Output Type: -
• Other names: 17305457; 267-1007; 703DR1248D2060A

4. OPERATION
NOTE: All models display an 8 in all digits for
1 sec. at power-up.
700 Hour Meter (AC/DC)
To Display & Operate: Apply DC+ or AC hot to pin 1 and DC–
or AC neutral to pin 2. The accumulation of elapsed time is
indicated by the flashing hourglass icon. If power has been
applied for 5 seconds minimum, the accumulated time will be
stored in non-volatile memory when power is removed.
To Reset: (for Resettable Models) Apply DC+ or AC hot to pin
4 for
for 5 seconds minimum. The reset voltage must be at the
same level as the voltage used to power the unit.
701 Hour Meter (AC/DC or DC Only)
To Display: Apply DC+ or AC hot to pin 1 and DC– or AC neutral to
pin 2. The display is activated at this point but the elapsed time
will not be accumulated until a signal is applied to pin 3.
Note, for proper operation: Power must be applied to pins 1
& 2 before or coincident with pin 3.
To Operate: Apply DC+ or AC hot to pin 3 for
minimum (AC/DC model) or DC+ for 1 millisecond mimimum
(DC Only model). The accumulation of elapsed time is indicated
by the flashing hourglass icon. If power (pins 1 & 2) has been
1
/
2
second minimum while power (pins 1 & 2) is applied
16
1
/
2
second
!
applied for 5 seconds minimum, the accumulated
time will be stored in non-volatile memory when
power is removed.
To Reset: (for Resettable Models) Apply DC+ or AC
hot to pin 4 for
& 2) is applied for 5 seconds minimum. The reset voltage must
be at the same level as the voltage used to power the unit.
703 Counter (AC/DC or DC Only)
To Display: Apply DC+ or AC hot to pin 1 and DC– or AC
neutral to pin 2. The display is activated at this point but the
count will not be started until a signal is applied to pin 3.
Note, for proper operation: Power must be applied to pins 1
& 2 before or coincident with pin 3.
To Operate: Apply DC+ or AC hot to pin 3. The count is
incremented when the input signal is removed from pin 3. The
input signal must be applied for
model) or for 1 millisecond mimimum (DC Only model). If
power (pins 1 & 2) has been applied for 5 seconds minimum,
the incremented count will be stored in non-volatile memory
when power is removed.
To Reset: (for Resettable Models) Apply DC+ or AC hot to
pin 4 for
applied for 5 seconds minimum. The reset voltage must be at
the same level as the voltage used to power the unit.
1
/
2
second minimum while power (pins 1 & 2) is
1
/
2
second minimum while power (pins 1
17
1
/
2
second minimum (AC/DC
!