CUB70020 Red Lion Controls, CUB70020 Datasheet - Page 4

• Manufacturer Part Number: CUB70020
• Description: COUNTER 8-DIGIT RED BACKLIGHT
• Manufacturer: Red Lion Controls
• Series: CUB7r

Specifications of CUB70020

• Count Rate: 10kHz
• Number Of Digits/alpha: 8
• Input Type: Voltage, Switch Closure, Transistor Switch
• Voltage - Supply: 9 V ~ 28 V
• Display Type: LCD Backlit
• No. Of Digits / Alpha: 8
• Digit Height: 8.9mm
• Supply Voltage Range: 9V DC To 28V DC
• Operating Temperature Range: 0°C To +50°C
• Bezel Height: 28mm
• Bezel Width: 51mm
• Character Size: 9mm
• Character Type: 7
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Output Type: -
• Other names: RLC702

Red Lion Controls
20 Willow Springs Circle
York PA 17402
Tel [phone]
Fax [phone]
RESET OPTIONS (CUB7 SERIES)
Common will enable the front panel Reset button.
pulled low by either a mechanical switch or solid-state transistor switch.
Switch load is 15 µA (max. voltage drop 0.5 V) when on. The off-state leakage
current must be less than 2 µA
approximately 15 msec in Reset response.
BACKLIGHT OPTION (CUB7 SERIES)
VDC power supply. The external supply is connected between V+ and
Common terminals as shown by the solid line in the drawing.
BATTERY INSTALLATION
1. Remove all power to the unit before removing battery cover.
2. To remove battery cover, push upward in the direction of the arrow on rear
3. Remove old battery* and replace with an RLC battery (BNL10000).
4. Replace cover. The battery cover is keyed so that it cannot be placed upside
* - Dispose of properly.
Connecting a wire from the RST. EN. (Reset Enable) Input terminal to
Pulling the “RST.” input low causes the counter to reset. The “RST.” can be
Note: The RC protection circuit on the “RST.” Input causes a delay of
Optional backlight versions of the CUB7 series require an external 9-28
cover (See drawing at right), until the cover unlatches. Pull cover straight
out from unit to fully remove.
Observe proper polarity when replacing battery as shown in drawing.
down. The arrow on the rear of the cover should point toward the top of the
CUB7 series when properly installed
WARNING: When connecting the signal wiring for a backlit
WARNING: Lithium battery may explode if incinerated.
CUB7W measuring an AC input voltage, the neutral of the single
phase AC signal is connected to Terminal 1 (COM), and line (hot)
is connected to Terminal 4 (LS) as shown by the dashed line in the
drawing. The DC supply for the backlighting is connected between
V+ and Common as shown by the solid line in the drawing. Three
phase AC applications require an isolation transformer.
TROUBLESHOOTING
numbers listed.
For further technical assistance, contact technical support at the appropriate company
ORDERING INFORMATION
*Battery is included with unit.
For more information on Pricing, Enclosures & Panel Mount Kits refer to the
RLC Catalog or contact your local RLC distributor.
MODEL NO.
CUB7W *
CUB70 *
BNL
DESCRIPTION
Counter Positive Image Reflective
Counter W/Yel-Grn Backlighting
Counter W/Red Backlighting
Counter Positive Image Reflective
Counter w/Yel-Grn Backlighting
Counter w/Red Backlighting
3 V Lithium Battery
Fax [phone]
NL - 3821 BR Amersfoort
Tel [phone]
Red Lion Controls BV
Basicweg 11b
PART NUMBERS
CUB7W000
CUB7W010
CUB7W020
CUB70000
CUB70010
CUB70020
BNL10000
31, Kaki Bukit Road 3,
Red Lion Controls AP
#06-04/05 TechLink
Fax [phone]
Tel [phone]
Singapore 417818