WL35 Panduit Corp, WL35 Datasheet - Page 96
![no-image](/images/no-image-200.jpg)
WL35
Manufacturer Part Number
WL35
Description
LABEL WARN HOT SURFACE 50/PK
Manufacturer
Panduit Corp
Type
Labelr
Datasheet
1.PCV-480BY.pdf
(112 pages)
Specifications of WL35
Label Type
Caution Hot Surface Warning (Symbol)
Label Size
2.000" (50.80mm) Triangle
Color
Black Legend, Yellow Background
For Use With/related Products
Heat Warning
H4
Tagout device. A prominent warning device, such as a tag and a means
of attachment, which can be securely fastened to an energy isolating device
in accordance with an established procedure, to indicate that the energy
isolating device and the equipment being controlled may not be operated
until the tagout device is removed.
..1910.147(c)
1910.147(c)
General -
1910.147(c)(1)
Energy control program. The employer shall establish a program consisting
of energy control procedures, employee training and periodic inspections to
ensure that before any employee performs any servicing or maintenance on
a machine or equipment where the unexpected energizing, startup or
release of stored energy could occur and cause injury, the machine or
equipment shall be isolated from the energy source and rendered
inoperative.
1910.147(c)(2)
Lockout/tagout.
1910.147(c)(2)(i)
If an energy isolating device is not capable of being locked out, the
employer's energy control program under paragraph (c)(1) of this section
shall utilize a tagout system.
1910.147(c)(2)(ii)
If an energy isolating device is capable of being locked out, the employer's
energy control program under paragraph (c)(1) of this section shall utilize
lockout, unless the employer can demonstrate that the utilization of a tagout
system will provide full employee protection as set forth in paragraph (c)(3)
of this section.
1910.147(c)(2)(iii)
After January 2, 1990, whenever replacement or major repair, renovation or
modification of a machine or equipment is performed, and whenever new
machines or equipment are installed, energy isolating devices for such
machine or equipment shall be designed to accept a lockout device.
1910.147(c)(3)
Full employee protection.
1910.147(c)(3)(i)
When a tagout device is used on an energy isolating device which is
capable of being locked out, the tagout device shall be attached at the same
location that the lockout device would have been attached, and the employer
shall demonstrate that the tagout program will provide a level of safety
equivalent to that obtained by using a lockout program.
..1910.147(c)(3)(ii)
1910.147(c)(3)(ii)
In demonstrating that a level of safety is achieved in the tagout program
which is equivalent to the level of safety obtained by using a lockout
program, the employer shall demonstrate full compliance with all tagout-
related provisions of this standard together with such additional elements as
are necessary to provide the equivalent safety available from the use of a
OSHA Standard 29CFR
The Control of Hazardous Energy
(Lockout/Tagout) 1910.147 (continued)