TMX-353-0512G SL Power Electronics Manufacture of Condor/Ault Brands, TMX-353-0512G Datasheet - Page 2

• Manufacturer Part Number: TMX-353-0512G
• Description: PS TRI OUT,DC IN 5,12,-12V
• Manufacturer: SL Power Electronics Manufacture of Condor/Ault Brands
• Series: TMXr
• Type: Isolatedr

Specifications of TMX-353-0512G

• Output: 5V, ±12V
• Number Of Outputs: 3
• Power (watts): 350W
• Mounting Type: Chassis Mount
• Voltage - Input: 40 ~ 60V
• Package / Case: Module
• 1st Output: 5 VDC @ 50A
• 2nd Output: 12 VDC @ 12A
• 3rd Output: -12 VDC @ 4A
• 4th Output: -
• Size / Dimension: 10.75" L x 4.80" W x 2.50" H (273.1mm x 121.9mm x 63.5mm)
• Operating Temperature: 0°C ~ 50°C
• Power (watts) - Rated: 350W
• Efficiency: 75%
• Approvals: CE, CSA, TUV, UL
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

SPECIFICATIONS: ALL MODELS
INPUT
DC Input: 40-60 Vdc. Internally fused for 15 A.
Efficiency: 75% typical.
Low Input Provides TTL “0” when input is below 40 Vdc.
OUTPUT
Adjustability: Outputs #1 and 2, and 4 factory adjusted to nominal ±0.2%. Output #3 tracks
Line & Load Reg: Outputs #1, 2, and 4 hold ±2% (with local sense) over dc input range and 0
Ripple & Noise: 1% p-p or 100 mV, whichever is greater.
Remote Sense (Output #1): Compensates for 250 mV total line drop. Preprogrammed slope
Temperature Coefficient (Outputs #1, 2, and 4): 0.03% per degree C.
Stability: 0.1% over 8 hours after 30 minutes warm-up.
Transient Response (Outputs #1, 2, and 4): Output voltage returns to within 1% in less than
Overload Protection: All outputs are protected against overload and short circuit. Automatic
Overvoltage Protection (Outputs #1 and 2): Protects load against power supply induced over-
Peak Output Current: Dual current ratings define continuous and peak currents. The peak
Remote Inhibit: Contact closure to the negative sense line or a TTL level “0” turns off DC
Redundancy: Built-in OR-ing diodes, slope program current sharing on all outputs, and self
Remote Enable: Contact closure to common turns on DC outputs (recessed pin for “make
DC Power Good: Provides a TTL “1” open collector when output #1 is above 4.6 V nominal.
Reverse Voltage: Protected against reverse voltage up to supply current rating.
ENVIRONMENTAL
Thermal Protection: Shuts down power supply if overheated. Automatic recovery.
Holdup Time: 20 ms minimum after removal of power at full load.
Temperature Range: 0° to 50°C at full ratings.
Safety Agencies: Most models are approved to UL1950; CSA 22.2 #234; IEC 950 and TÜV
Conducted RFI: Meets FCC Part 15, Subpart J, Class A; EN55022 Class B and CISPR 22 Class B.
Cooling: Self-cooled by internal ball-bearing fan.
Output Isolation: Isolated from ground 50 Vdc.
#2; initial accuracy ±3%.
to 100% load change (preprogrammed slope). Output #3 requires 20% minimum load on
outputs #2 and 3 to hold ±5%.
remains under ±3% worst case. Open sense lead protection.
500 µs for a 50% load change (measured with rise time and fall time of 200 µs). Peak
transient does not exceed 5%.
recovery upon removal of fault.
voltage. Trip point is factory set so that output voltage cannot exceed 136% of nominal.
current shown can be delivered for a maximum period of 30 seconds.
outputs.
aligning connector provide “hot swap” and “N+1” capabilities. Current sharing remains
within 10% of the unit’s full output rating while units are in thermal equilibrium.
last, break first” connection).
EN60950, Class 1 SELV., CE 72/23/EEC/93/68EEC (low voltage directive).
Dimensions:
Condor D.C. Power Supplies, Inc., A subsidiary of SL Industries, Inc. 805-486-4565 • [phone] Fax: [phone] http://www.condorpower.com
Millimeters
Inches
3.8 lbs - 1.7 kgs
TMX-350
OPTIONS
Consult factory for available options.
DC INPUT
DC OUTPUT
STATUS AND CONTROL
J1-22
J1-24
J1-11
Remote Sense
DC Power Good
Enable
Inhibit
Battery Low
Output #1
Output #2
Output #3
Output #4
FUNCTION
FUNCTION
FUNCTION
J1- 10, 20, 30
J1 - 9, 19, 29
J1-2
J1-3
J1-4
J1-3
J1-5
J1-6
J1-18
J1-8
J1-7
J1-16
J1-27
J1-17
LOCATION
LOCATION
Safety Ground
+48 Vdc
-48 Vdc
48 Vdc
350 WATTS
10.75”x 4.8”x 2.5”
TMX-350
Output #1 Sense
Output #1 Sense Rtn
Reference to Common
when #1 Sense Rtn
is terminated
Reference
to Common
Main Output
Rtn (Common)
Rtn (Common)
Rtn (Common)
(+) Floating
(–) Floating
Output
Output
NOTES
NOTES
See below
See above
Positronics #
PLC30M400A1-168.3
Mates with panel
mounted
PLC30F1000
connector using
crimp contacts
FC114N2
(14 to 16 AWG)
CONNECTOR
CONNECTOR
CONNECTOR