LP0603A0947ANTR\500 AVX Corporation, LP0603A0947ANTR\500 Datasheet - Page 5

• Manufacturer Part Number: LP0603A0947ANTR\500
• Description: LOW PASS FILTER 947MHZ 0603 SMD
• Manufacturer: AVX Corporation
• Series: LP0603r

Specifications of LP0603A0947ANTR\500

• Package / Case: 0603 (1608 Metric)
• Mounting Type: Surface Mount
• Frequency: 947.5MHz Center
• Filter Type: Low Pass
• Bandwidth: 25MHz
• Insertion Loss: 0.35dB
• Product: Low Pass Filters
• Ripple: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Ripple: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

TEST JIG FOR LP0603 LEAD-FREE LGA LOW PASS FILTER
GENERAL DESCRIPTION
These jigs are designed for testing the LP0603 LGA Low
Pass Filters using a Vector Network Analyzer.
They consist of a dielectric substrate, having 50Ω microstrips
as conducting lines and a bottom ground plane located at a
distance of 0.127mm from the microstrips.
The substrate used is Neltec’s NH9338ST0127C1BC (or
similar).
The connectors are SMA type (female), ‘Johnson
Components Inc.’ Product P/N: 142-0701-841 (or similar).
Both a measurement jig and a calibration jig are provided.
The calibration jig is designed for a full 2-port calibration, and
consists of an open line, short line and through line. LOAD
calibration can be done by a 50Ω SMA termination.
Thin-Film Low Pass Filter
LP0603 Lead-Free LGA Type Test Jig
Connector 1
Connector 2
Measurement
Short line to
GND
Load &
Through
MEASUREMENT PROCEDURE
Follow the VNA’s instruction manual and use the
jig
widths.
Solder the filter to the
Input
(Filter)
Output
(Filter)
Set the VNA to the relevant frequency band. Connect the
VNA using a 10dB attenuator on the jig terminal connected
to port 2 (using an RF cable).
to perform a full 2-Port calibration in the required band-
Calibration Jig
➨ Connector 2 (Jig)
➨ Connector 1 (Jig)
measurement jig
Load &
OUT
Open
line
GND (Filter) ➨ GND (Jig)
GND (Filter) ➨ GND (Jig)
as follows:
Connector
Johnson
P/N 152-0701-841
calibration
85
4