80610980072 3M Interconnect Solutions, 80610980072 Datasheet - Page 2

• Manufacturer Part Number: 80610980072
• Manufacturer: 3M Interconnect Solutions

Specifications of 80610980072

• Lead Free Status / RoHS Status: Supplier Unconfirmed

800/245-3573
Important Notice to Purchaser:
Electrical Products Division
6801 River Place Blvd.
Austin, TX 78726-9000
www.3M.com/elpd
Before using this product, you must evaluate it and determine if it is suitable for your intended application. You assume all risks and liability
associated with such use.
Warranty: Limited Remedy: Limited Liability. This product will be free from defects in material and manufacture as of the date of the purchase.
3M MAKES NO OTHER WARRANTIES INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS
FOR A PARTICULAR PURPOSE. If this product is defective within the warranty period stated above, your exclusive remedy shall be, at 3M's option,
to replace or repair the 3M product or refund the purchase price of the 3M product. Except where prohibited by law, 3M will not be liable for any loss
or damage arising from this product, whether direct, indirect, special, incidental or consequential regardless of the legal theory asserted.
Figure 1
Figure 3
Installation:
1. Position Cold Shrink Assembly
2. Install bulkhead termination connector according to manufacturer recommendations
3. Use mastic seal strips (or roll) from kit to fill gap over NPT threads of connector fitting
4. CPT–1/2, CPT–3/4 and CPT–1 Only: Position Cold Shrink Adapter Assembly as shown
5. Position Cold Shrink Corrosion Protection Assembly
NOTE: CPT–1/2, CPT–3/4 & CPT–1 Kits contain two Cold Shrink Assemblies. Position smaller adapter
release liners before wrapping. Build mastic level to flats of hex nut (or flush with surface for round profile connectors).
Mastic material may be folded to ease wrapping.
unwinding loose core pull tab in a counter-clockwise direction around cable.
unwinding loose core pull tab in a counter-clockwise direction around cable. Rubber sleeve should make contact with
enclosure wall during installation.
NOTE: Plastic core is recyclable
NOTE: If a hub is installed between termination and junction box, the cold shrink should be positioned
a max of 2" onto the hub. (No mastic required).
Pull Tabs
assembly
Pull Tab
(Figure 1) over cable last.
Cable Prep End
(Figure 1) over cable jacket. Direct loose core pull tab over cable as shown.
Recycled paper
40% preconsumer
10% post-consumer
(Figure 4) over bulkhead termination connector. Install by
Pull Tab
Figure 2
Figure 4
(Figure 2–Typical).
Enclosure Wall
(Figure 2). Remove white
If hub present, see note above.
Mastic Seal
(Figure 3). Install by
© 3M 1999 78-8120-1052-4-C