SLUFDM512MU1UI-B STEC, SLUFDM512MU1UI-B Datasheet - Page 8
![no-image](/images/no-image-200.jpg)
SLUFDM512MU1UI-B
Manufacturer Part Number
SLUFDM512MU1UI-B
Description
Manufacturer
STEC
Type
Flash Diskr
Datasheet
1.SLUFDM512MU1UI-B.pdf
(18 pages)
Specifications of SLUFDM512MU1UI-B
Density
512MByte
Operating Supply Voltage (typ)
5V
Operating Temperature (min)
-40C
Operating Temperature (max)
85C
Package Type
Not Required
Operating Temperature Classification
Industrial
Operating Supply Voltage (min)
4.75V
Operating Supply Voltage (max)
5.25V
Programmable
Yes
Lead Free Status / RoHS Status
Compliant
SLUFDMxxx(M/G)U1U(I)-y
Datasheet
3.1.2 Controller external components
In addition to the functional blocks shown in Figure 4, the USB Flash Disk Module has the following
external components:
3.2
Since the USB Flash Disk Module provides a standard USB interface to the host, no software
integration is required, providing the shortest time-to-market for design engineers.
The firmware of the embedded USB 2.0 controller contains STEC’s advanced flash memory
management algorithms to ensure the most optimum device performance, reliability and endurance.
It was designed to maximize the benefits of flash memory, while at the same time overcoming
inherent NAND flash limitations. Implemented in firmware are the below features:
3.2.1 Bad Block Management
Inherent to NAND flash technology are areas (blocks) on the media that cannot be used for storage
because of their high error rate. These so-called “bad blocks” are already identified by the flash
vendor during manufacturing, but can also be accumulated over time during device operation.
The USB 2.0 controller contains a table that lists all the bad blocks on the device (Bad Block Table),
and automatically maps out these blocks upon system initialization. During device operation it
ensures that newly accumulated bad blocks are also mapped out and added to the Bad Block Table.
Bad block management is 100% transparent to the host application, which will not be aware of the
location or existence of bad blocks on the media.
3.2.2 Wear Leveling
The SLC NAND flash devices that are being used in the USB Flash Disk Module are guaranteed for
100,000 Write/Erase cycles per block. This means that after approximately 100,000 erase cycles, the
erase block has a higher probability for errors than the error rate that is typical to the flash. While
100,000 write/erase cycles may be good for consumer data storage, such as digital cameras, MP3
players, etc., it is not sufficient for industrial and embedded applications where data is constantly
written to the device and long product life is required.
For example, operating systems that use a file system, will update the File Allocation Table (FAT)
every time a write is done to the device. Without any wear leveling in place, the area on the flash
where the FAT table is located would wear out faster than other areas, reducing the lifetime of the
entire flash device.
To overcome this limitation, the flash management algorithm needs to make sure that each block in
the device ages, i.e. is “worn out”, at the same rate. The built-in wear leveling scheme makes sure
SLC NAND Flash for the most reliable data storage.
Crystal Oscillator 12Mhz, as the main clock source.
Flash file system management
Bad-block management
Wear-leveling
Power failure management
Performance optimization
Flash Management
61000-03606-115, May 2007
USB Flash Disk Module
8