M38510/21002BJA E2V, M38510/21002BJA Datasheet - Page 3

• Manufacturer Part Number: M38510/21002BJA
• Manufacturer: E2V

Specifications of M38510/21002BJA

• Lead Free Status / RoHS Status: Supplier Unconfirmed

http://assist.daps.dla.mil
Philadelphia, PA 19111-5094.)
cited herein, the text of this document takes precedence. Nothing in this document, however, supersedes
applicable laws and regulations unless a specific exemption has been obtained.
a manufacturer authorized by the qualifying activity for listing on the applicable qualified manufacturers list before
contract award (see 4.3 and 6.3).
as specified herein or as modified in the device manufacturer’s Quality Management (QM) plan. The
modification in the QM plan shall not affect the form, fit, or function as described herein.
be as specified in MIL-PRF-38535 and herein.
itme drawing shall be as specified on figure 2. When required in groups A, B, or C (see 4.4), the devices shall be
programmed by the manufacturer prior to test in a checkerboard pattern (a minimum of 50 percent of the total
number of bits programmed) or to any altered item drawing pattern which includes at least 25 percent of the total
number of bits programmed.
item drawing.
6.6).
table I, and apply over the full recommended case operating temperature range, unless otherwise specified.
applicable, the altered item drawing. The electrical tests for each subgroup are described in table III.
(Copies of these documents are available online at
2.3 Order of precedence. In the event of a conflict between the text of this specification and the references
3. REQUIREMENTS
3.1 Qualification. Microcircuits furnished under this specification shall be products that are manufactured by
3.2 Item requirements.
3.3 Design, construction, and physical dimensions. The design, construction, and physical dimensions shall
3.3.1 Terminal connections. The terminal connections shall be as specified on figure 1.
3.3.2 Truth table
3.3.2.1 Unprogrammed devices. The truth table for unprogrammed devices for contracts involving no altered
3.3.2.2 Programmed devices. The truth table for programmed devices shall be as specified by the altered
3.3.3 Functional block diagram. The functional block diagram shall be as specified on figure 3.
3.3.4 Case outlines. The case outlines shall be as specified in 1.2.3.
3.4 Lead material and finish. The lead material and finish shall be in accordance with MIL-PRF-38535 (see
3.5 Electrical performance characteristics. The electrical performance characteristics are as specified in
3.6 Electrical test requirements. The electrical test requirements shall be as specified in table II, and where
3.7 Marking. Marking shall be in accordance with MIL-PRF-38535.
or from the Standardization Document Order Desk, 700 Robbins Avenue, Building 4D,
The individual item requirements shall be in accordance with MIL-PRF-38535 and
MIL-M-38510/210E
http://assist.daps.dla.mil/quicksearch/
3
or