SI4700DY-T1 Vishay, SI4700DY-T1 Datasheet - Page 7
![no-image](/images/manufacturer_photos/0/6/697/vishay_sml.jpg)
SI4700DY-T1
Manufacturer Part Number
SI4700DY-T1
Description
Manufacturer
Vishay
Datasheet
1.SI4700DY-T1.pdf
(9 pages)
Specifications of SI4700DY-T1
Lead Free Status / RoHS Status
Not Compliant
The Si4700 is designed to be used to select one of two power
sources for a circuit, such as needed to implement ACPI in
desktop computers. In this application, parts of the circuit must
run off an always-on power supply when the computer is in
suspend mode. When in normal mode, these circuits run off
the main power supply.
The Si4700DY contains an n-channel MOSFET and a
p-channel MOSFET switch connected together to make a
single-pole, double-throw switch. An additional on-board small
signal MOSFET provides a ground referenced logic input.
When the control input is high, the power MOSFET gates are
pulled to ground, and the p-channel MOSFET is on. When the
input is low, the gates are pulled above the supply rail, and the
n-channel MOSFET is on (pulling the gate of the p-channel
above the source potential has no effect).
The gate drive for the n-channel device, Q1, uses an external
12-V supply via an external resistor. A typical value for this
resistor is around 20 k , but the value is not critical as long as
the current in Q3 is kept below 0.05 A. A higher value of
resistance reduces the current while in suspend mode, but
also introduces a longer delay when turning on Q1.
Document Number: 71110
S-00025—Rev. A, 24-Jan-00
Seconday supply
Main Supply
ACPI Control
(always on)
FIGURE 1.
Main power supply shutdown
control in ATX power supply
ACPI Power Switching Application
New Product
Circuit
Main
The Si4700DY switch is a break-before-make configuration,
therefore sufficient capacitance must be present on the
isolated load to ensure hold up during switching. Due to fast
switching times this should not be significant and is preferred
over a make-before-break that would connect the two power
supplies directly for a short period.
Note that the n-channel MOSFET is oriented to ensure that the
internal diode does not conduct while the sub-circuit is
isolated. In this direction it also provides a fail-safe path for the
circuit’s power through the diode. The forward drop of the
p-channel
back-feeding the secondary supply, assuming the two
supplies are very close in voltage.
The Si4700DY has a maximum r
n-channel MOSFET used during normal operation and 70 m
for the p-channel used when the computer is in suspend,
making it ideal for loads up to 3 A or higher depending on
voltage drop requirements. It can be used on any rail voltage
between 2.5 V and 8 V (based on an absolute max of 12 V),
with a logic input between 2.5-V and 5-V nominal.
SPDT switch required to isolate cir-
cuit and connect to V
MOSFET’s
Always-On
STANDBY
diode
Circuit
www.vishay.com FaxBack 408-970-5600
Vishay Siliconix
will
DS(on)
block
of 30 m
Si4700DY
any
current
for the
2-7