PPC405EP-3GB200C Applied Micro Circuits Corporation, PPC405EP-3GB200C Datasheet - Page 43
![no-image](/images/manufacturer_photos/0/0/70/applied_micro_circuits_corporation_sml.jpg)
PPC405EP-3GB200C
Manufacturer Part Number
PPC405EP-3GB200C
Description
Manufacturer
Applied Micro Circuits Corporation
Datasheet
1.PPC405EP-3GB200C.pdf
(51 pages)
Specifications of PPC405EP-3GB200C
Family Name
405EP
Device Core
PowerPC
Device Core Size
32b
Frequency (max)
200MHz
Instruction Set Architecture
RISC
Supply Voltage 1 (typ)
1.8V
Operating Supply Voltage (max)
1.95V
Operating Supply Voltage (min)
1.65V
Operating Temp Range
-40C to 85C
Operating Temperature Classification
Industrial
Mounting
Surface Mount
Pin Count
385
Package Type
EBGA
Lead Free Status / RoHS Status
Not Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
PPC405EP – PowerPC 405EP Embedded Processor
Spread Spectrum Clocking
Care must be taken when using a spread spectrum clock generator (SSCG) with the PPC405EP. This controller
uses a PLL for clock generation inside the chip. The accuracy with which the PLL follows the SSCG is referred to
as tracking skew. The PLL bandwidth and phase angle determine how much tracking skew there is between the
SSCG and the PLL for a given frequency deviation and modulation frequency. When using an SSCG with the
PPC405EP the following conditions must be met:
Notes:
Caution: It is up to the system designer to ensure that any SSCG used with the PPC405EP meets the above
requirements and does not adversely affect other aspects of the system.
AMCC
1. The serial port baud rates are synchronous to the modulated clock. The serial port has a tolerance of approx-
2. Operation of the PPC405EP PCI Bridge is unaffected by the use of an SSCG.
3. Ethernet operation is unaffected.
4. IIC operation is unaffected.
•
•
•
•
imately 1.5% on baud rate before framing errors begin to occur. The 1.5% tolerance assumes that the
connected device is running at precise baud rates. If an external serial clock is used the baud rate is unaf-
fected by the modulation.
The PCI controller must be operated in asynchronous mode. When in asynchronous mode, the PCI bus clock
must be driven into the PPC405EP PCIClk input. In this configuration the PCI controller supports the
66.66 MHz PCI clock specification which specifies a maximum frequency deviation of -1% at a modulation of
between 30 kHz and 33 kHz.
The frequency deviation must not violate the minimum clock cycle time. Therefore, when operating the
PPC405EP with one or more internal clocks at their maximum supported frequency, the SSCG can only
lower the frequency.
The maximum frequency deviation cannot exceed −3%, and the modulation frequency cannot exceed
40kHz. In some cases, on-board PPC405EP peripherals impose more stringent requirements (see Note 1).
Use the peripheral bus clock (PerClk) for logic that is synchronous to the peripheral bus since this clock
tracks the modulation.
Use the SDRAM MemClkOut since it also tracks the modulation.
Revision 1.08 – March 24, 2008
Data Sheet
43