JGB-12LYAA1 JDS UNIPHASE, JGB-12LYAA1 Datasheet - Page 16

• Manufacturer Part Number: JGB-12LYAA1
• Manufacturer: JDS UNIPHASE

Specifications of JGB-12LYAA1

• Lead Free Status / RoHS Status: Not Compliant

JGB-12SYAA1
JGB-12LYAA1
Gigabit Ethernet GBIC
Notes for Short Wavelength Optical Characteristics
Page 16 of 30
1. Launched optical power is measured at the end of a two meter section of a 50/125 m fiber for the shortwave GBICs, and a 9/125 m
2. Optical rise time is determined by measuring the 20% to 80% response of average maximum values using an oscilloscope and 4th
3. Extinction Ratio is the ratio of the average optical power (in dB) in a logic level one to the average optical power in a logic level zero
4. RIN
5. Coupled Power Ratio is the ratio of average power coupled into a multimode fiber to the average power coupled into a single mode
6. The minimum and maximum values of the average received power in dBm allow the input power range to maintain a BER < 10
7. The Rx_LOS has hysteresis to minimize “chatter” on the output line. In principle, hysteresis alone does not guarantee chatter-free
fiber for the longwave GBICs. The maximum and minimum of the allowed range of average transmitter power coupled into the fiber
are worst case values to account for manufacturing variances, drift due to temperature variations, and aging effects.
order Bessel Thompson filter having a 3 dB bandwidth of 0.75 nominal baud rate. The measurement is corrected to the full band-
width value. Optical fall times are measured using a 6 GHz photodetector followed by a 22 GHz sampling oscilloscope. No correc-
tions due to filtering or system bandwidth limitations are made on the measured value.
measured under fully modulated conditions with a pattern of five 1s followed by five 0s, in the presence of worst case reflections.
Deterministic Jitter is measured as the peak-to-peak timing variation of the 50% optical signal crossings when transmitting repetitive
K28.5 characters.
fiber. The single mode fiber should be single mode at the wavelength of interest. This measurement is defined in EIA/TIA-526-14A.
Additionally, the values shall be time averaged while the multimode test jumper is shaken and bent to simulate temperature and
time variations of the laser.
when the data is sampled in the center of the receiver eye. These values take into account power penalties caused by the use of a
laser transmitter with a worst-case combination of spectral width, extinction ratio, and pulse shape characteristics.
operation. These GBICs, however, present an Rx_LOS line without chatter, where chatter is defined as a transient response having
a voltage level of greater than 0.5 volts (in the case of going from the negate level to the assert level) and of any duration that can
be sensed by the host logic.
12
is the laser noise, integrated over a specified bandwidth, measured relative to average optical power with 12 dB return loss.
GBIC.1250
03/06/02
-12