AT88SC6416C-PI Atmel, AT88SC6416C-PI Datasheet - Page 10

• Manufacturer Part Number: AT88SC6416C-PI
• Manufacturer: Atmel

Specifications of AT88SC6416C-PI

• Operating Temperature (max): 85C
• Operating Temperature (min): -40C
• Package Type: PDIP
• Mounting: Through Hole
• Pin Count: 8
• Operating Temperature Classification: Industrial
• Lead Free Status / RoHS Status: Not Compliant

8.
9.
9.1.
10
Security Fuses
There are three fuses on the device that must be blown during the device personalization process. Each fuse locks
certain portions of the configuration memory as OTP memory. Fuses are designed for the module manufacturer, card
manufacturer and card issuer and should be blown in sequence, although all programming of the device and blowing of
the fuses may be performed at one final step.
Protocol Selection
The AT88SC6416C supports two different communication protocols.
Smart Card Applications: The asynchronous T = 0 protocol defined by ISO 7816-3 is used for compatibility with the
Embedded Applications: A 2-wire serial interface is used for fast and efficient communication with logic or controllers.
The power-up sequence determines which of the two communication protocols will be used.
Asynchronous T = 0 Protocol
This power-up sequence complies with ISO 7816-3 for a cold reset in smart card applications.
• V
• Set I/O-SDA in receive mode.
• Provide a clock signal to CLK-SCL.
• RST goes high after 400 clock cycles.
The device will respond with a 64-bit ATR code, including historical bytes to indicate the memory density within the
CryptoMemory family. Once the asynchronous mode has been selected, it is not possible to switch to the synchronous
mode without powering off the device.
Figure 10.
After a successful ATR, the Protocol and Parameter Selection (PPS) protocol, as defined by ISO 7816-3, may be used
to negotiate the communications speed with CryptoMemory devices 32 Kbits and larger. CryptoMemory supports
D values of 1, 2, 4, 8, 12, and 16 for an F value of 372. Also supported are D values of 8 and 16 for F = 512. This
allows selection of 8 communications speeds ranging from 9600 baud to 153,600 baud.
AT88SC6416C
CLK-SCL
I/O-SDA
CC
RST
goes high; RST, I/O-SDA and CLK-SCL are low.
V cc
Asynchronous T = 0 Protocol (Gemplus Patent)
industry’s standard smart card readers.
ATR
5015KS–SMEM–08/09