FFD35-U3S-48-P80-P SanDisk, FFD35-U3S-48-P80-P Datasheet - Page 54

• Manufacturer Part Number: FFD35-U3S-48-P80-P
• Manufacturer: SanDisk
• Type: Flash Diskr

Specifications of FFD35-U3S-48-P80-P

• Density: 48GByte
• Operating Supply Voltage (typ): 5V
• Operating Temperature (min): 0C
• Operating Temperature (max): 70C
• Package Type: Not Required
• Mounting: Socket
• Pin Count: 80
• Operating Temperature Classification: Commercial
• Operating Supply Voltage (min): 4.5V
• Operating Supply Voltage (max): 5.5V
• Programmable: Yes
• Lead Free Status / RoHS Status: Supplier Unconfirmed

11.6.2.
After installing the SSD as described in Section ‎ 1 1.6.1, it must be installed as a disk drive under
DOS. Run the DOS commands listed below and follow the instructions displayed for each
command. For more information regarding the DOS commands, refer to your DOS manual.
1. Run the DOS FDISK utility to partition the SSD. If you want the SSD to be a bootable
2. Run the DOS Format command to high-level format the SSD.
3. If you want the SSD to be a bootable drive, run the DOS SYS command.
Note: Some SCSI host adapters require the installation of a device driver to access SCSI disk
54
drive, run Set Active Partition using the FDISK utility.
drives. In this case, follow the instructions included with your adapter to configure the
system and install the SSD as another drive under DOS. (The SSD is not bootable under
this scenario.)
Only internal devices:
Only external devices:
Internal and external devices:
Using the SSD in MS-DOS-Based Platforms
SCSI device 1
Terminated
Termination
Enabled
SCSI device 2
not
terminated
SCSI device 5
Terminated
Figure 13: SCSI Cable Connection and Termination Configuration
PC SCSI
adapter
SCSI device 0
not
terminated
Termination
Disabled
Product Specification and User Manual
SCSI BUS
SCSI BUS
PC SCSI
adapter
SCSI device 0
not
terminated
Termination
Enabled
External
Terminator >
SCSI BUS
SCSI BUS
SSD (Formerly FFD) Ultra320 SCSI 3.5"
^ ^
External
Terminator
PC SCSI
adapter
SCSI device 3
Terminated
through
SCSI device 0
not
terminated
SCSI device 3
Terminated
through
43-PS-0305-00 Rev. 2.2