SLATAFL1GBJ STEC, SLATAFL1GBJ Datasheet - Page 8
![no-image](/images/no-image-200.jpg)
SLATAFL1GBJ
Manufacturer Part Number
SLATAFL1GBJ
Description
Manufacturer
STEC
Type
ATA Cardr
Datasheet
1.SLATAFL1GBJ.pdf
(42 pages)
Specifications of SLATAFL1GBJ
Density
1GByte
Operating Supply Voltage (typ)
3.3/5V
Operating Temperature (min)
0C
Operating Temperature (max)
70C
Package Type
Not Required
Mounting
Socket
Pin Count
68
Operating Temperature Classification
Commercial
Operating Supply Voltage (min)
3.18/4.75V
Operating Supply Voltage (max)
3.465/5.25V
Programmable
Yes
Lead Free Status / RoHS Status
Not Compliant
SimpleTech P/N:
(where xxx=capacity; U=RoHS compliant lead-free; I=Ind. Op. Temp;
F=fixed device; S=small data packet optimized)
SIGNAL DESCRIPTIONS
-WAIT
(PC Card Memory Mode)
-WAIT
(PC Card I/O Mode)
IORDY
(True IDE Mode)
GND
(PC Card Memory Mode)
GND
(PC Card I/O Mode)
GND
(True IDE Mode)
VCC
(PC Card Memory Mode)
VCC
(PC Card I/O Mode)
VCC
(True IDE Mode)
RESET
(PC Card Memory Mode)
RESET
(PC Card I/O Mode)
-RESET
(True IDE Mode)
-VS1
-VS2
(PC Card Memory Mode)
-VS1
-VS2
(PC Card I/O Mode)
-VS1
-VS2
(True IDE Mode)
Signal Name
SLATAFLxxxJ(U)(I)-(F)(S)
Dir
—
—
O
O
I
1, 34, 35, 68
17, 51
Pin
59
58
43
57
(continued)
This signal is not used by the card, and is pulled up to VCC through a 4.7K
ohm resistor.
This signal is not used by the card, and is pulled up to VCC through a 4.7K
ohm resistor.
This signal is not used by the card, and is pulled up to VCC through a 4.7K
ohm resistor.
Ground
Ground
Ground
+5 V or 3.3V power
+5 V or 3.3V power
+5 V or 3.3V power
When RESET is high, this signal resets the card. The card is reset only at
power up if this signal is left high or open from power-up. The card can
also be reset when the soft reset bit in the Card Configuration Option
Register is set.
This signal is the same as the PC Card Memory Mode signal.
In the True IDE Mode this input pin is the active low hardware reset from
the host.
read at either 3.3 volts or 5.0 volts.
This signal is the same for all models.
This signal is not used in IDE Mode.
-VS1 is grounded, and -VS2 is not connected so that the card CIS can be
Document Part Number 61000-02810-110 July 2005
Description
PC CARD
Page 8