XR16L2450IJ-F Exar Corporation, XR16L2450IJ-F Datasheet - Page 10

• Manufacturer Part Number: XR16L2450IJ-F
• Description: 2.25 To 5.5V W/ 5V TOLERANT DUART
• Manufacturer: Exar Corporation

Specifications of XR16L2450IJ-F

• Features: *
• Number Of Channels: 2, DUART
• Fifo's: 1 Byte
• Protocol: RS232
• Voltage - Supply: 2.25 V ~ 5.5 V
• With False Start Bit Detection: Yes
• With Modem Control: Yes
• With Cmos: Yes
• Mounting Type: Surface Mount
• Package / Case: 44-LCC (J-Lead)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

xr
XR16L2450
2.25V TO 5.5V DUART
REV. 1.1.1
2.11
Receiver
The receiver section contains an 8-bit Receive Shift Register (RSR) and 1 byte FIFO or Receive Holding
Register (RHR). The RSR uses the 16X clock for timing. It verifies and validates every bit on the incoming
character in the middle of each data bit. On the falling edge of a start or false start bit, an internal receiver
counter starts counting at the 16X clock rate. After 8 clocks the start bit period should be at the center of the
start bit. At this time the start bit is sampled and if it is still a logic 0 it is validated. Evaluating the start bit in this
manner prevents the receiver from assembling a false character. The rest of the data bits and stop bits are
sampled and validated in this same manner to prevent false framing. If there were any error(s), they are
reported in the LSR register bits 2-4. Once the data is received, the error tags are immediately updated to
reflect the status of the data byte in RHR register. RHR will generate a receive data ready interrupt upon
receiving a character if IER bit-0 has been enabled.
2.11.1
Receive Holding Register (RHR) - Read-Only
The Receive Holding Register is an 8-bit register that holds a receive data byte from the Receive Shift
Register. It provides the receive data interface to the host processor. The RHR register is part of the 1 byte
receive FIFO that is 11-bits wide, the 3 extra bits are for the 3 error tags to be reported in LSR register. After the
RHR is read, LSR bits 2-4 willl immediately be updated to reflect the errors for the next character byte
transferred from the RSR.
F
6. R
O
IGURE
ECEIVER
PERATION
16X Clock
Receive Data Shift
Data Bit
Register (RSR)
Validation
Receive Data Characters
Error
Receive
Receive Data
Tags in
Data Byte
RHR Interrupt (ISR bit-2)
Holding Register
LSR bits
and Errors
(RHR)
4:2
RXFIFO1
10