USB2512-AEZG Standard Microsystems (SMSC), USB2512-AEZG Datasheet - Page 57
![no-image](/images/manufacturer_photos/0/6/632/standard_microsystems__smsc__sml.jpg)
USB2512-AEZG
Manufacturer Part Number
USB2512-AEZG
Description
Manufacturer
Standard Microsystems (SMSC)
Datasheet
1.USB2512-AEZG.pdf
(76 pages)
Specifications of USB2512-AEZG
Operating Supply Voltage (typ)
3.3V
Operating Supply Voltage (min)
3V
Operating Supply Voltage (max)
3.6V
Operating Temp Range
0C to 70C
Operating Temperature Classification
Commercial
Mounting
Surface Mount
Pin Count
36
Lead Free Status / RoHS Status
Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
USB2512-AEZG
Manufacturer:
SMSC
Quantity:
5 600
Company:
Part Number:
USB2512-AEZG
Manufacturer:
Standard
Quantity:
6
Part Number:
USB2512-AEZG
Manufacturer:
SMSC
Quantity:
20 000
USB 2.0 Hi-Speed Hub Controller
Datasheet
SMSC USB251x
RESET_N
Strap Pins
8.7
8.7.1
8.7.1.1
VSS
VSS
Hardware
asserted
reset
Don’t Care
USB2513/13i and USB2514/14i Only: The LED_A[x:1]_N pins are sampled after RESET_N negation,
and the logic values are used to configure the hub if the internal default configuration mode is selected.
The implementation shown in
configured with a "Strap High" configuration, the LED functions with active low signaling, and the PAD
will "sink" the current from the external supply. When a pin is configured with a "Strap Low"
configuration, the LED functions with active high signaling, and the PAD will source the current to the
external LED.
There are two different resets that the hub experiences. One is a hardware reset via the RESET_N
pin and the second is a USB Bus Reset.
External Hardware RESET_N
A valid hardware reset is defined as assertion of RESET_N for a minimum of 1 μs after all power
supplies are within operating range. While reset is asserted, the hub (and its associated external
circuitry) consumes less than 500 μA of current from the upstream USB power source.
Assertion of RESET_N (external pin) causes the following:
1. All downstream ports are disabled, and PRTPWR power to downstream devices is removed (unless
2. The PHYs are disabled, and the differential pairs will be in a high-impedance state.
3. All transactions immediately terminate; no states are saved.
4. All internal registers return to the default state (in most cases, 00(h)).
5. The external crystal oscillator is halted.
6. The PLL is halted.
The hub is “operational” 500 μs after RESET_N is negated. Once operational, the hub immediately
reads OEM-specific data from the external EEPROM (if the SMBus option is not disabled).
RESET_N for Strapping Option Configuration
Reset
BC_EN is enabled).
Read Strap
t1
Options
Figure 8.6 Reset_N Timing for Default/Strap Option Mode
t2
Valid
t3
Don’t Care
t4
Figure 8.5
Drive Strap
Outputs to
inactive
levels
DATASHEET
t5
57
shows a recommended passive scheme. When a pin is
Upstream
Attach
USB
Driven by Hub if strap is an output.
USB Reset
recovery
t6
t7
Idle
Revision 1.1 (04-26-10)
t8
completion
response
request
Start