90800-2 TE Connectivity, 90800-2 Datasheet - Page 4

• Manufacturer Part Number: 90800-2
• Description: Connector Accessories Crimp Die Set
• Manufacturer: TE Connectivity
• Type: Die Setr

Specifications of 90800-2

• Wire Size (awg): 28-22
• Rohs Compliant: NA
• Lead Free Status / RoHS Status: RoHS Not Applicable
• For Use With: SDE Crimp Hand Tool
• Lead Free Status / Rohs Status: RoHS Exempt Product

6. CRIMP HEIGHT INSPECTION
This inspection requires the use of a micrometer with
a modified anvil. Tyco Electronics recommends the
modified micrometer (Crimp Height Comparator
RS–1019–5LP) which may be purchased from:
Proceed as follows:
PRO-CRIMPER III Hand Tool Assembly and Die Assembly
CAUTION
Shearer Industrial Supply Co.
4. Hold the contact in position and squeeze the
tool handles together until ratchet engages
sufficiently to hold the contact in position. Do NOT
deform insulation barrel or wire barrel.
5. Insert stripped wire into contact insulation and
wire barrels until it is butted against the wire stop,
as shown in Figure 3.
6. Holding the wire in place, squeeze tool handles
together until ratchet releases. Allow tool handles
to open and remove crimped contact.
NOTE
7. Check the contact’s crimp height as described in
Section 6, CRIMP HEIGHT INSPECTION. If
necessary, adjust the crimp height as described in
Section 7, CRIMP HEIGHT ADJUSTMENT.
1. Refer to Figure 4 and select a wire (maximum
size) for each crimp section listed.
2. Refer to Section 5, CRIMPING PROCEDURE,
and crimp the contact(s) accordingly.
3. Using a crimp height comparator, measure the
wire barrel crimp height as shown in Figure 4. If the
crimp height conforms to that shown in the table,
the tool is considered dimensionally correct. If not,
the tool must be adjusted. Refer to Section 7,
CRIMP HEIGHT ADJUSTMENT.
i
717–767–7575
are started evenly into the crimping section. Do
NOT attempt to crimp an improperly positioned
contact.
The crimped contact may stick in the crimping
area, but the contact can be easily removed by
pushing downward on the top of the locator (see
Figure 3).
ake sure that both sides of the insulation barrel
or
610–691–3205
VALCO
7. CRIMP HEIGHT ADJUSTMENT
AWG (MAX)
WIRE SIZE
1. Remove the lockscrew from the ratchet
adjustment wheel.
2. With a screwdriver, adjust the ratchet wheel
from the locator side of the tool.
(WIRE SIZE MARKING)
CRIMP SECTION
Figure 4
Figure 5
TOLERANCE (+)
CRIMP HEIGHT
DIM. (A) AND
08- 007
B