IRDC3802 International Rectifier, IRDC3802 Datasheet - Page 15

• Manufacturer Part Number: IRDC3802
• Manufacturer: International Rectifier

Specifications of IRDC3802

• Lead Free Status / RoHS Status: Supplier Unconfirmed

Stencil Design
•
•
Rev 0.1
6/16/2008
The Stencil apertures for the lead lands should be approximately 80% of the area
of the lead lads. Reducing the amount of solder deposited will minimize the
occurrences of lead shorts. If too much solder is deposited on the center pad the
part will float and the lead lands will be open.
The maximum length and width of the land pad stencil aperture should be equal to
the solder resist opening minus an annular 0.2mm pull back to decrease the
incidence of shorting the center land to the lead lands when the part is pushed into
the solder paste.
IRDC3802