DEMO9S08EL32 Freescale, DEMO9S08EL32 Datasheet - Page 11

• Manufacturer Part Number: DEMO9S08EL32
• Manufacturer: Freescale

Specifications of DEMO9S08EL32

• Lead Free Status / RoHS Status: Supplier Unconfirmed

U S E R
LIN Communications
The DEMO9S08EL32 applies a fault tolerant, Local Interconnect Interface (LIN) physical layer
(PHY) for use in developing automotive control applications. The PHY supports LIN bus
functionality for input voltages between +12V and +18V. Only power applied to the PWR
connector or through the LIN bus enable LIN functionality. Two, 4-pin, Molex connectors
provide off-board connectivity. Figure 5 below shows the pin-out of the LIN connector looking
into the connector.
Figure 5: LIN Connector
LIN_EN
The LIN_EN option header can be used to disable the LIN PHY under MCU control. The LIN
PHY is enabled by default if this header is removed. Figure 6 shows the LIN_EN shunt
positions.
Figure 6: LIN_EN Option Header
COM_SEL
The COM_SEL option header connects the MCU SCI port to either the SCI PHY or the LIN
PHY. Figure 7 below shows jumper setting selecting between SCI or LIN signalling.
G U I D E
LIN I/O
NOTE: +12V must be applied to the PWR connector when using the LIN functionality.
GND
VX_EN
1
2
4
2
3
1
Enabled
ON
V
GND
SUP
Disabled
OFF
REF: Mating Connector, Molex P/N,
39-01-2040, Housing
39-00-0039, Socket
11