5EFM1C Tyco Electronics, 5EFM1C Datasheet - Page 3

• Manufacturer Part Number: 5EFM1C
• Description: 5EFM1C=F8106
• Manufacturer: Tyco Electronics
• Series: Mr
• Type: IEC 320-C14 (Male Pins)r

Specifications of 5EFM1C

• Current: 5A
• Features: Fuse Holder
• Filter Type: General Purpose
• Fuse Drawer: Included
• Mounting Type: Panel Mount, Snap-In
• Termination Style: Quick Connect - .110" (2.8mm)
• Voltage: 250VAC
• Voltage Rating: 250 VAC
• Current Rating: 5 A
• Mounting Style: Snap-In
• Filtered: Yes
• Leakage Current: 0.5 mA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 2-1609129-2; 2-6609129-2

Dimensions are in inches and millimeters unless otherwise specified. Values in italics are metric
equivalents. Dimensions are shown for reference purposes only. Specifications subject to change.
1 1
100V
0 0
2 2
230V
0 0
3 3
3 3
2 2
0 0
0 0
1 1
Slim Power Entry Module Family with Multiple Options
2 2
0 0
1 1
120V
240V
4 4
2 2
4 4
0 0
0 0
2 2
1. Remove power cord
2. Insert a pocket screwdriver at point “X” as shown
3.
4. When the fuse holder is installed in the single fuse position,
5. Install one (1) AG fuse or two (2) metric fuses (see below)
6. Replace fuse holder into housing
7. Swing and push to snap door back in place
Gently lift the entire door UP approximately 1/4"
Once lifted, the door will pivot on it’s hinges to expose
the fuse holder
apply the screwdriver as shown and gently lift up
Use screwdriver as shown, do not use fingers
When the fuse holder is installed in the dual fuse position,
it will normally release as soon as the door is opened
Install fuses on one side only, do not install
both G and metric fuses at the same time
Lift Up
USA Cust. Svc.:
Corcom Prods:
Germany:
BEFORE REPLACING FUSES
1-800-468-2023
1-847-680-7400
USE ONLY WITH
DISCONNECT POWER
250V FUSES
A
A
49-89-6089-0
Insert Here
NOT here
“X”
Section A-A
(minimum)