ATA5756-6DQY71 Atmel, ATA5756-6DQY71 Datasheet - Page 7
![RF Transmitter ASK/FSK Transmitter 315MHz TPMS](/photos/30/99/309936/tssop-10_sml.jpg)
ATA5756-6DQY71
Manufacturer Part Number
ATA5756-6DQY71
Description
RF Transmitter ASK/FSK Transmitter 315MHz TPMS
Manufacturer
Atmel
Type
UHF ASK/FSK Transmittersr
Datasheet
1.ATAB5756.pdf
(20 pages)
Specifications of ATA5756-6DQY71
Package / Case
TSSOP-10
Operating Frequency
315 MHz
Maximum Operating Temperature
125 C
Mounting Style
SMD/SMT
Operating Supply Voltage
2 V to 3.6 V
Supply Voltage (max)
3.6 V
Supply Voltage (min)
2 V
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
4.2
4.2.1
4.2.2
4702J–RKE–09/08
Transmission with ENABLE = High
FSK Mode
ASK Mode
The ATA5756/ATA5757 is activated by ENABLE = High, FSK = High and ASK = Low. The micro-
controller is then switched to external clocking. After typically 0.6 ms, the CLK driver is activated
automatically (i.e., the microcontroller waits until the XTO and CLK are ready). After another
time period of
on with ASK = H. The ATA5756/ATA5757 is then ready for FSK modulation. The microcontroller
starts to switch on and off the capacitor between the crystal load capacitor and GND by means
of pin FSK, thus, changing the reference frequency of the PLL. IF FSK = L the output frequency
is lower, if FSK = H output frequency is higher. After transmission, ASK is switched to Low and
the microcontroller returns back to internal clocking. Then, the ATA5756/ATA5757 is switched to
power-down mode with ENABLE = Low and FSK = Low.
Figure 4-3.
The ATA5756/ATA5757 is activated by ENABLE = High, FSK = High and ASK = Low. After acti-
vation the microcontroller is switched to external clocking. After typically 0.6 ms, the CLK driver
is activated automatically (the microcontroller waits until the XTO and CLK are ready). After
another time period of
then be modulated by means of pin ASK. After transmission, ASK is switched to Low and the
microcontroller returns back to internal clocking. Then, the ATA5756/ATA5757 is switched to
power-down mode with ENABLE = Low and FSK = Low.
ENABLE
ASK
FSK
CLK
≤
Timing FSK Mode with ENABLE Connected to the Microcontroller
250 µs, the PLL is locked and ready to transmit. The power amplifier is switched
Power-down
≤
250 µs, the PLL is locked and ready to transmit. The output power can
ΔT
XTO
Power-up,
PA off
> 250 µs
(f
Power-up,
RF
PA on
= High)
ATA5756/ATA5757
(f
Power-up,
RF
PA off
= Low)
Power-down
7