1-1579007-6 Tyco Electronics, 1-1579007-6 Datasheet
1-1579007-6
Manufacturer Part Number
1-1579007-6
Description
AMP MCP Interconnection System
Manufacturer
Tyco Electronics
Type
Extraction Toolr
Specifications of 1-1579007-6
Tool Type
Extraction Tool
Product
Extraction Tool
Lead Free Status / RoHS Status
Not applicable / Not applicable
For Use With/related Products
Junior Power Timer Contacts
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
1. INTRODUCTION
This instruction sheet covers the use of Extraction
Tool 1–1579007–6, which is designed to remove
Junior Power Timer (JPT) receptacle contacts and
2.8mm tab contacts from Junior Power Timer (JTP)
and 2.8mm housings.
2. DESCRIPTION
Extraction Tool 1–1579007–6 consists of a tool
handle, tool cover with locking latches, and an
extraction tool tip. Refer to Figure 1.
The extraction tool tips are designed to enter the
contact cavity in front of the connector and release
the receptacle contact. When the extraction tool tips
are bottomed in the contact cavity, the tips depress
the locking lances of the receptacle contact. The
contact can be removed from the housing by
manually pulling on the wire.
3. EXTRACTION PROCEDURE
PROPER USE GUIDELINES
E
NOTE
NOTE
Dimensions on this sheet are in millimeters
unless otherwise specified. Figures are not drawn
to scale.
The secondary lock cover on the Junior Power
Timer (JPT) and 2.8mm tab connectors must be
in the pre-lock or open position before attempting
to remove a contact.
Figure 1
Extraction Tool 1-1579007-6
1. Depress the locking latches (Figure 1) on the
extraction tool cover and slide the cover to expose
the extraction tool tips.
2. While holding the connector, grasp the wire at
the rear of the housing and push forward toward
the mating end to disengage the contact locking
lances from the connector cavity shoulder. See
Figure 2.
3. Fully insert the extraction tool tips into the
windows of the circuit cavity until it bottoms inside
the window. The tips of the tool should straddle the
contact to be extracted. See Figure 3.
4. Remove the contact from the connector by
pulling on the wire attached to it.
www.tycoelectronics.com
Figure 2
Figure 3
408-8943
1
1-1579007-6 Summary of contents
Page 1
... Timer (JPT) and 2.8mm tab connectors must be in the pre-lock or open position before attempting to remove a contact. E Extraction Tool 1-1579007-6 1. Depress the locking latches (Figure 1) on the extraction tool cover and slide the cover to expose the extraction tool tips. 2. While holding the connector, grasp the wire at ...
Page 2
... Additional tools may be ordered from: CUSTOMER SERVICE (38–35) TYCO ELECTRONICS CORPORATION P.O. BOX 3608 HARRISBURG, PA 17105–3608 5. REVISION SUMMARY New release per EC 0990–1038– Extraction Tool 1-1579007-6 40 408-8943 65 107 Figure 4 Rev O ...