05113841139 3M Interconnect Solutions, 05113841139 Datasheet - Page 4

• Manufacturer Part Number: 05113841139
• Description: Conn DIN 41612 SKT 96 POS 2.54mm IDT RA Cable Mount
• Manufacturer: 3M Interconnect Solutions
• Type: DIN 41612r

Specifications of 05113841139

• Pitch: 2.54 mm
• Number Of Rows: 3
• Number Of Contacts: 96
• Termination Method: IDT
• Mounting: Cable Mount
• Contact Plating: Gold Over Nickel

Important Notice
PRODUCT USE: All statements, technical information and recommendations contained in this document are based upon tests or
experience that 3M believes are reliable. However, many factors beyond 3M’s control can affect the use and performance of a 3M
product in a particular application, including the conditions under which the product is used and the time and environmental conditions
in which the product is expected to perform. Since these factors are uniquely within the user’s knowledge and control, it is essential
that the user evaluate the 3M product to determine whether it is fi t for a particular purpose and suitable for the user’s application.
Warranty; Limited Remedy; Limited Liability.
3M’s product warranty is stated in its Product Literature available upon request. 3M MAKES NO OTHER WARRANTIES INCLUDING,
BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. If this
product is defective within the warranty period stated above, your exclusive remedy shall be, at 3M’s option, to replace or repair the
3M product or refund the purchase price of the 3M product. Except where prohibited by law, 3M will not be liable for any indirect,
special, incidental or consequential loss or damage arising from this 3M product, regardless of the legal theory asserted.
Customer and Technical Service
Within the U.S.:
Customer Service: 800-225-5373
Technical Support: 512-984-6703
Outside of the U.S.:
For customer service and technical support, please contact your local 3M Electronic Solutions Division representative.
3M is a trademark of 3M Company.

Electronic Solutions Division
Interconnect Products
6801 River Place Blvd.
Austin, TX 78726-9000
800-225-5373
www.3Mconnector.com
4.5
4.6
Lower the ASSEMBLY PRESS HANDLE
firmly to complete the Cable/Connector
Assembly. (See Figure 8.)
Raise the press handle and remove the
completed assembly. Visually inspect to
ensure that:
a. Cover is fully seated and parallel with
b. Cable is properly aligned with the cover
c. Cover retaining devices on the body are
the body.
grooves.
flush with the cover end.
Please recycle. Printed in USA.
© 3M 2010
78-9101-0518-4
Figure 8