SI3201-FSR Silicon Laboratories Inc, SI3201-FSR Datasheet - Page 109

• Manufacturer Part Number: SI3201-FSR
• Description: SLIC 1-CH 60dB 41mA 3.3V/5V 16-Pin SOIC EP T/R
• Manufacturer: Silicon Laboratories Inc

Specifications of SI3201-FSR

• Package: 16SOIC EP
• Number Of Channels Per Chip: 1
• Longitudinal Balanced: 60 dB
• Loop Current: 41 mA
• Minimum Operating Supply Voltage: 3.13 V
• Typical Operating Supply Voltage: 3.3|5 V
• Typical Supply Current: 88 mA

4.4. FSK Control
For detailed instructions on FSK signal generation, refer to “Application Note 32: FSK Generation” (AN32). These
registers support enhanced FSK generation mode, which is enabled by setting FSKEN = 1 (direct Register 108,
bit 6) and REL = 1 (direct Register 32, bit 6).
Addr.
Addr. D15
69
70
71
72
73
74
69
70
71
72
73
74
FSK Amplitude Coefficient for Space.
When FSKEN = 1 and REL = 1, this register sets the amplitude to be used when gener-
ating a space or 0. When the active timer (OAT1) expires, the value of this register is
loaded into oscillator 1 instead of OSC1X.
FSK Frequency Coefficient for Space.
When FSKEN = 1 and REL = 1, this register sets the frequency to be used when gener-
ating a space or 0. When the active timer (OAT1) expires, the value of this register is
loaded into oscillator 1 instead of OSC1.
FSK Amplitude Coefficient for Mark.
When FSKEN = 1 and REL = 1, this register sets the amplitude to be used when gener-
ating a mark or 1. When the active timer (OAT1) expires, the value of this register is
loaded into oscillator 1 instead of OSC1X.
FSK Frequency Coefficient for Mark.
When FSKEN = 1 and REL = 1, this register sets the frequency to be used when gener-
ating a mark or 1. When the active timer (OAT1) expires, the value of this register is
loaded into oscillator 1 instead of OSC1.
FSK Transition Parameter from 0 to 1.
When FSKEN = 1 and REL = 1, this register defines a gain correction factor that is
applied to signal amplitude when transitioning from a space (0) to a mark (1).
FSK Transition Parameter from 1 to 0.
When FSKEN = 1 and REL = 1, this register defines a gain correction factor that is
applied to signal amplitude when transitioning from a mark (1) to a space (0).
D14
D13
Table 43. FSK Control Indirect Registers Description
Table 42. FSK Control Indirect Registers Summary
D12
D11
D10
Description
D9
Rev. 1.0
FSK0X[15:0]
FSK1X[15:0]
FSK01[15:0]
FSK10[15:0]
FSK0[15:0]
FSK1[15:0]
D8
D7
D6
D5
D4
D3
D2
Reference Page
39 and AN32
39 and AN32
39 and AN32
39 and AN32
39 and AN32
39 and AN32
Si3216
D1
D0
109