SOLO 100-001 NO CLIMB, SOLO 100-001 Datasheet - Page 5

• Manufacturer Part Number: SOLO 100-001
• Description: POLE, TELESCOPIC, 4-SECTION, 4.5M
• Manufacturer: NO CLIMB

Specifications of SOLO 100-001

• Svhc: No SVHC (18-Jun-2010)
• External Length / Height: 4.5m
• Lead Free Status / RoHS Status: na

Solo 461 Cordless Heat Detector Tester
Instructions for use
Insert a charged Battery Baton
into tool & pole
• Tool will automatically start testing when infra-red beam in cup is broken
• Green LED will flash faster
• Hold in place until the alarm is activated*
• When the detector alarms, remove the tool from the detector
• It will revert to standby mode (slow flashing green LED) and the internal
(*If the detector fails to activate it may be faulty. Insert a replacement detector and test again)
Notes
Useful Tips:
• Tool features an automatic power-saving feature,
• Only use with Solo™ Battery Baton™ and only charge the Battery Baton™
• It is normal for the Battery Baton™ to get slightly warm during use
• Never block the ventilation hole in the side of the cup, which ensures correct airflow
blower will cool the heating element for a few seconds
which will turn it off after five minutes if not used
with the Solo™ Charger (see Page 9 for charging instructions)
LED flashing red=warning battery nearly discharged - Normal testing can continue
LED constantly red=battery fully discharged or error - Testing cannot continue
LED flashing red/green=Tool automatically terminated test - Time exceeded 120 sec
After testing, switch off at red switch to
preserve battery life
Press the red switch to turn on
LED illuminates green
Flash at slow rate indicates
normal STANDBY mode.
[ 8 ]
Position the latch
& place over detector
Solo 461 Battery Charging Instructions and
General Information
• International power outlet cables available from your supplier
• Connect battery to charger
• Fast Charge LED will illuminate
• When battery is fully charged,
• Trickle charge LED will illuminate
fast charge LED will extinguish
• Ideally fully discharge in normal use
[ 9 ]
before recharge
• Connect charger to power outlet
• Power LED will illuminate
or lighter socket in vehicle
using mains lead supplied or
the umbilical DC connecting
lead